Model WIXE 127 instruction manual I have lost the one provided with new machine

If it sounds like an aeroplane it's probably bearings u/s

Most likely have to change the door lock and latch assembly.

The only way you can find out where the leak is coming from is by removing the back and putting water in it. Using a torch try to see where it is leaking from. TBH its usually the door boot (the rubber seal around the inside of the door). As for the noise.... Open the door and take hold of the shiny part of the drum inside. (Just that bit). Try moving it up and down. If there is any play in it and it rocks a little that is your bearings going and can be an expensive repair. Hope that helps.

Hi

Error code F05 means that the pressure switch is jammed on full.
Remove lower rear cover of washer.
Locate and remove the large black fastened to bottom of the drum.
Remove and clean plastic filter inside hose.
Remove hose onto pump, and check for blockage or obstruction here as well.
Hope this helps you.

Hi and welcome to FixYa, I am Kelly.
Per the model number you provided in your post (WDDH-820EAH) this is your user's Manual:
http://www.orientalpacific.com/backend/files/products/manuals/127/WDH-820EAH%20User%20Manual.pdf

Note the comment about air filter cleaning on the back of the unit every 2 weeks.
Thanks for choosing FixYa,
Kelly

It can actually depend on the programme you have selected.
You have to select a programme that will accept a 1200 spin, as not all programmes do.
Hope this helps.

Check the solenoid belongs to that tray.It may struck.

CLICK HERE

http://www.miaudioaddiction.com/fixya/manual.pdf

Please download asap - as it is stored on my personal FTP site, and will be removed in 48 hours.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question





Head over to the manufacturer's website.

Typically they have a SUPPORT section - where you enter the FULL model number, and then can download a FREE manual.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

You will find there are something like coins trapped in the filter, stopping it turning, get some pliers & try turning it backwards & forwards to dislodge the blockage. If this doesn't work you may have to force the filter & buy anew one

i think there is a problem with low water level sensor
My 127 fill up with water and i have f-08 error code which is a high level water sensor faulty