I have bosch classic, the fuse goes off after 5

FROM FIXYA

Sanja Salatic NOV 29, 2009

The e2 error is a generic error that the machine shows if it's been overloaded or if the load becomes unbalanced during a wash cycle.

to fix you must do a master reset of the washing machine.

1. Close the door and make sure the dial is pointing to the "OFF" function
2. Hold the Start/Pause button and turn the dial anti clockwise (to the left) to the "express 15 min" program at the same time.
3. Hold the Start/Pause button for a minute (the e2 message is meant to start flashing after a minute of holding the button down however with my washing machine this didn't happen)
4. Release the button and turn the dial back to the "Off" function.
5. Select any program and the message should not be appearing.
--------------------------

You can google your question for answer
About 15,800 results (0.65 seconds)
Took about 2 seconds to find answer. Look in the instructions that came with unit.
ttps://bosch-dishwasher-errors.com/bosch-dishwasher-error-code-e04/

Disconect power completely, wait 5 minutes, reconnect power. Still flashing, needs serviceman

This will be the heating element.

try unplugging washer for 5 mins then plug back up should reset!

clean the sensor which is located underneath the lint trap

Check at front door top. You may have to open the screws around the door.

Hello Sir,
I think that this is due to a faulty Main box Fuse. This usually happens when the heating elements of the washer go on. Try to inspect for faults, cracks or breakages in fuse box or in switches.

Thank you Sir,
Have a nice day.

slimline classic xx bosh dishwasher not pumping out water??