When I try to use the oven it read error f-3. It does not heat up Any idea whats wrong? It is a whirlpool model. model-rf364bbdqos\n-fe2401557whirlpool oven with error code-f3

No make or model I service Whirlpool products normally a bad temperature will give an F error code and turn on the cooling fan I would check the temperature sensor should read appx. 1080 ohms at room temp.

I am not sure about this, but sounds like a connector is on backwards or in the wrong place.

that's a bad touch panel or key panel,the number you sent isn't the full model number off of the oven so when you call to order the part you will need that.if you try to fix this yourself make sure the power is off.good luck

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101

Hi,

Before you go working too hard to get you oven to go into the self clean mode(self destruct)....check out this tip...

Self Cleaning Oven Problem


heatman101

" Wish I had read this first. I never would have used the self cleaning option. Thanks for the info!!

F3-E2 Oven over heat Replace Sensor

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

E1 F2 means bad connection between touch pad and control board. if connections are ok it may require parts. may get very expensive.

F1 Board failure Replace control board (also called ERC or clock).

after cleaning the oven the bake temp would not go any higher than 350. when you press the temp button to go lower or higher it only go down. could you tell me what is wrong or what to do.

i have the same problem oven comes on but goes back off. help