My Whirlpool stylemaster 907675 Washer wont spin.. The lid switch is fine.. Washes fine and all other cycles work.. just wont spin.

MOST LIKELY DOOR SWITCH OR LID SWITCH. PART NUMBER WP8318084

Hey I'm an expert on this! You have a bad Drain Pump. It happens very frequently because of the amount of work it does. Replace it and your machine will return to Glory!

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

lid switch broken

Good day,
Almost always the lid switch.
Here is a good tutorial on replacing it. It should be noted there are 3 different lid switches depending on your model, and as well, the screws that hold the top console may be in 3 different locations.
Bottom left and right, bottom left and right but under plastic end caps that have to be unclipped and finally on the bottom but at the rear.
Kenmore's are built by Whirlpool.


http://www.youtube.com/watch?v=fC8SY3cU1Yc

Theres an electric water valve. You have to find out if its the hot or cold thats leaking and replace it.

You most likely have a bad lid switch. I have a pictorial that shows how to get to that lid switch
HERE
On this 2nd page HERE I have found a movie on youtube that shows how to get into this washer

















If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Definetly the lid switch has been knocked out of place or has gone bad.

I’m happy to help further over the phone at https://www.6ya.com/expert/josh_87ce33216d7b2148

press in clips each corner with putty knife and lift top remove screws bottom front panel slide panel down and off ..locate pump. turn washer to spin and switch on if faint hum felt at pump more than likely plugged with something if pump is running fine ck for something in drain lines..most washers i would say lid switch but on those i believe if switch was bad wouldn't aditate either ck by raising lid ..if agitates with lid raised ck lid switch if not switch ok

Check your lid switch it's probably broken.