Top-load Kenmore 24872300 agitator dosen't move,just clicks

if everything works but it wont spin, you need to replace your agitator dogs. they are in the top of the agitator. one bolt under the agitator cap. the dogs come in a 4 pack and cost about 3 bucks.

When the cycle doesn't advance, it's probably the timer or a cold-water supply problem:

It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer.

It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.

if you are saying that the washer finishes the load of clothes and timer goes to off and water is filling the tub after this then you have a bad water valve on the back of the washer.disconnect the water lines and change out the valve

You need a timer the motor contacts are probably burnt.

Your machine has no belt. It has a direct drive coupling. The direct drive coupling between the motor and transmission must be replaced.

you hae a stuck float switch, it shuts water off when it reaches a certain height, fixing it involes removing the top of the washer (not easily done)

This is usally a timer problem that is shorted

No agitation or spin in any cycle? If so and the machine will drain check the coupler.

Hello aksward,
Welcome to Fixya.

Here are some suggestions for any Kenmore washers

Let me know how it goes. I'm still thinking and searching my repair manuals!
Huuum
Please remember to leave a rating!

KENMORE ELITE TOP LOAD

Washer stops, won't fill, rinse or agitate


• Check the following:
Is the power cord plugged into a grounded 3 prong outlet?
Is the indicator on the Cycle Control knob properly lined up
with a cycle? Turn the Cycle Control knob to the right slightly
and pull to start.
Are the water inlet valve screens clogged?
Are both the hot and cold water faucets turned on?
Is the water inlet hose kinked?
• Does the water level seem too low, or does the washer
appear to not fill completely? The top of the agitator is
much higher than the highest water level. This is normal and
necessary for clothes to move freely.
• Has a fuse blown or is the circuit breaker open? If problem
continues, call an electrician.
• Are you using an extension cord? Do not use an extension
cord.
• Is the washer in a normal pause in the cycle? The washer
pauses for about 2 minutes during certain cycles. Allow the
cycle to continue. Some cycles feature periods of agitation
and soak.
• Is the washer overloaded? Wash smaller loads.
• Is the lid open? The lid must be closed during operation.
Washer will not agitate or spin with the lid open.

sounds like a timer problem