COMPAQ PRESARIO SR1010V!!!

Your Computer system is not POSTing see my guides below they will help you get it going again.

My published guides are entitled;

How to Remove the Side Panels of My Computer Chassis!!!

next up
How do I reset my BIOS/CMOS to defaults?

For the grand finale
My Computer is not turning on!!! Is it dead!!! No POST!!!

Happy Testing!!!
damnor01

Try disconnecting the A/C source.
Allow unit to set for 5 minutes.
Re-install power and restart uint.
If that does not work, Disconnect power and remover supply connections at the motherboard.
Allow to set for afew minutes, and re-connect.
Sometime, removing the connections at the motherboard, allows the supply to reset.
You should have a 4 pin video connection and a 24 pin main board connection.
Note. Make sure your power is disconnected before attempting this service.

try installing from control panel

install th eproper driver provided with the mouse

go to control panel -device manager and see if you have all the latest drivers downloaded and if u dont then i would try and update them. if that doesnt work search up the specific driver u need online and download and install it.

Hi,
Before i can suggest any steps i need to know since when u have this pblm and what are the softwares and hardwares you had installed recently,please revert back with details for more assistance......:)

Does 1 Usb port work on your computer? Sometimes they can go out. Do you have a USB hub you can use?

Appears to be a bad motherboard. Replace it.

If the hard drive is is not damage maybe you can save all important files on it.

Please do the step by step troubleshooting of your laptop.
REmove the following:

1. Memory
2. hard drive
3. processor:
4. Battery

try this;
1. Fix some other connection inside the laptop
2. Insert AC plug then start the system.
3. shutdown the system
4. Insert the processor
5. swittch on the laptop.
If beeping; continue
step 3;
6 insert the memory.
7. start the system
8. If display, connect the harddrive.

in step 5: if not beeping:

Either board or processor is dead.


IN step 8.
9. start the system.
10. if the hard drive is detected, and cannot continue booting
i recommend you to reinstall the windows.

Please notify me if problems arises. i will give you further instruction, melnavz.