Fault light flashing,

The stop light and the spin light flashing are acting as an error code. Have you tried to google what this means? here is a link to candy error codes for that machine...
http://www.ukwhitegoods.co.uk/help/fix-it-yourself/fault-codes/laundry-fault-codes/3319-candy-grando-washing-machine-series-fault-codes.html

hope that helps

tun the fault codes to determine the possible fault sensor
indicates a crank/cam position sensor

If your laptop appears to boot up and the hard disk LED flashes, then the problem is probably a back light fault. This can be a faulty inverter or a faulty CCFL lamp. Please click on this link and follow my instructions to identify the fault and possible fix :- http://www.fixya.com/support/r3598095-faulty_laptop_lcd_screen

Anyone got an answer to this, as I have exactly the same fault.

Dishwasher appears to switch on OK, then after a short time (20 secs?) the pump noise stops and the green light flashes - it seems to e a sequence of 7 flashes, then stop... 7 flashed then stop.

The sequence could indicate a fault detected?

Anyone know anything about these units from IKEA, made by Whirlpool?

Thanks!

S

If the flash fires but the photos are dark, this typically indicates a fault with one of the following:
- fault of the main transistor that triggers the flash
- fault of the fiber optic cable that connects the flash head with the body

What you have to understand is that when you see one flash in operation, on a properly functioning unit there are actually two flashes in sequence. The first, pre-flash is used for metering the scene, then the follow up is the actual flash that gives the light in the photograph. If the transistor is faulty then it may just discharge the capacitor during the pre-flash, not leaving any energy left for the main flash. If the fiber optic cable is broken (it is very fragile), then the metering stage fails and the flash logic decides to abort the main flash.

It sounds like your inverter is at fault. You will need an inverter tester ( most good service techs will have one ) to prove that the output to the compressor is correct. If the inverter is okay then it will be the compressor at fault with a location error or it is simply seized. A common fault that caused this was the eev remained closed (coil failure ) and caused the compressor to over heat.

hi abs light indicating you have sensor down on brakes or master cilinder is on its way out,try checking sensor will need to go to a back street garage cheaper

the problem you are getting is a f01 fault,this is water in the base part of the antiflood devise.to check this if you tip the appliance backwards and water comes from the back at the bottom this is the problem,if you do this till it stops and then leave for approx 24hrs to dry out any water that may have gone on to motor,then check by switching on to start a program,if appears to work ok but then goes back to the same fault(draining all the time and light flashing)you will have to remove base and check for leaks.

Check your filters. Manual says they need to be cleaned every two weeks under normal operation (and in my case more often during renovations). It seems it may not take much to limit air flow enough for the indoor unit to trip out. Hope this helps.

hiya
these machines will do this if the timer dial has been moved during a cycle, they have a memory chip on the main circuit board.

they also do this if the machine has a fault with the exception that they dont stop, the doorlock light flashes and the timer just keeps clicking.

try setting the timer to a dot on the settings then switching the power on, the doorlock light will flash a few times, turn off again select program then switch back on, machine should now be reset and work ok, if not then count the flashes of the doorlock light as this indicates a fault code.

hope this helps


please dont forget to rate the helpfulness of this reply thanks kj