Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher Logo

Related Topics:

Anonymous Posted on Jan 03, 2010

Dd603 info only acrid smell/smoke from upper

Dd603 - info only- acrid smell/smoke from upper drawer assy.
disassembled cres steel cover and found microcontroller and main harness edge connector (white wire harness to pwr board) burnt /melted. mains circuit breaker never tripped. pwr board visual checks ok.
upper drawer micro control and harness requires replacement.
cause: conductive fluid soap/salts (very hard water) residue accumulation on foam insulation pad that nests inside cres steel cover panel, dripping onto microcontroller board edge contacts.

  • Anonymous Jan 03, 2010

    above harness part number anyone?

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Jan 04, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jan 03, 2010
Answers
2
Questions
1
Helped
6497
Points
2

INFO ONLY- POTENTIAL FLUIDS CONTAMINATING CIRCUIT BOARD
EDGE CONNECTORS

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Smoking motor

The only answer to this is to take it back to where you purchased it at or call Makita.
2helpful
2answers

2004 Chrysler Voyager, had an acrid burning smell and a lot of smoke when heater is turned on, also a rattling/squealing noise, all stops when heater turned off?

you more than likely have a sciezed air con compressor. most modern cars have climate control which uses air con even when demisting and when engaged the electric clutch tries to engage but the pump itself will not turn, clutch will get red hot and burn your belts
0helpful
1answer

96 chev 1500 w/6 cyl vortex, started running rough, then smells like gas, now engine light comes on and white smoke

Either your fuel injector assembly or fuel pressure regulator has gone bad. The intake cover (upper plenum) needs to be removed to inspect both. This motor has an internal pressure regulator that is prone to leaking, should be pretty obvious (puddles of fuel under and around regulator). If you remove the cover and see no fuel then suspect fuel injector assy. It has been updated to a new design so don't be alarmed if it looks different than the old one. Good luck
0helpful
1answer

NISSAN CEDRIC 2001, ENGIN STOPS WHEN PRESS BRAKE PEDDEL

There are few possibilities that can cause such problem.
I recommend you few help links related to your problem.Click the link below and follow the troubleshooting;-----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------
Brake pedal stuck? http://howtobyme.blogspot.in/2012/03/brake-pedal-stuck.html

-------------
Car only starts when gas pedal is pressed? http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html

----------
Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html

----------
emits whitish bluish smoke and bad fuel smell from exhaust

http://schematicsdiagram.blogspot.com/2011/12/van-emits-whitish-bluish-smoke-and-bad.html

----------
White smoke and Acrid Smell? http://whoisbyme.blogspot.in/2012/07/white-smoke-and-acrid-smell.html
---------- Car stalls and throws white smoke from exhaust? http://repairhelpcenter.blogspot.com/2012/01/car-stalls-and-throws-white-smoke-from.html

-----------
This will help.
Thanks.

0helpful
1answer

Hi, I have a Fisher & paykel DD603. A really bad smell has developed which appears to come from under the top panel encasing the dishwasher. How do I remove this panel to locate the source of this...

HI- If you mean the front panel they are removed by taking out the plastic retainers that are on each side of the drawer near the front and bottom of the drawer. They are round and about 1/2" in diameter and have a raised straight portion in the middle, they sit flush with the plastic sides. Use needle nose pliers and pull hard. Once both are out grab the bottom of the front panel and pull down, the panel should "slide" off. Be sure to have the power off to the unit (unplugged) because if there is an electrical short that is casing the short all the wires will be exposed and could give you a shock if they are melted. The controller will be in the upper right hand portion of the drawer front. Smell there. I've see them short out and be black and crispy. Good luck. Getting the panel back on is difficult but be patient and don't force it.
2helpful
1answer

It smells like dust burning on an electric

This only smells for 10 minutes and the smoke alarm will quit.
0helpful
1answer

Smoke from the engine, bad smelt

if its a sweet smell, and white smoke, antifreeze, acrid smell, wiring. oily smell, gray smoke, oil, rich pungent smell, black smoke, fuel. hope this helps!!!
0helpful
1answer

E-mail for Fisher Paykel DD603 manual

Josh, you will need to have a Tech out to look at it... F/P will not sell you parts to repair it. The F1 indicates that the flood switch has been tripped. There are many possible causes for this but probably the upper drawer link support has broken and is getting stuck between the lid and the drawer in which case you will need a new lid and link support.
0helpful
3answers

Fisher and Paykel DD603 service manual

Check to see if the Child lock is on...Check your email
Not finding what you are looking for?

379 views

Ask a Question

Usually answered in minutes!

Top Fisher and Paykel Dishwashers Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Paul Bade

Level 3 Expert

1818 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Fisher and Paykel Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...