After changing the color wheel in my samsung the screen is blue

The color wheel is acting up. It may need cleaning. Use extreme caution when cleaning the wheel. Never use paper like a kleenex or paper towel. This will ruin the surface of the wheel. It's best left to a pro.

Sometimes on the DM board of the light engine it has a small black jumper that sometimes needs to be removed and colors are restored, sometimes might need adjustments in service menu.

Do you mean that red and blue are reversed? If so, you may need to remove a jumper, see end of linked article. Pinkish-yellow or orange sounds like a good description of skin tone, but perhaps too intense. If the color is too intense, can you just lower the color level with the color control? Or can you just change the tint with the tint control? Otherwise, see http://www.jangro.com/electronics/samsung-dlp-replace-color-wheel/ including the comments at the end.

I pulled out a small jumper on the board behind the color wheel. There is a sticker indicating which one to pull. I assume that certain color wheels need this and others don't, mine apparently didn't.

two problems .out of that any one will solve the problem. the bulb or the colour wheel any out of that has to be checked and replaced.
how to replace the colour wheel with diagram and procedure
http://www.jangro.com/a/2006/07/24/samsung-dlp-replace-color-wheel/

how to replace the lamp in 5 minutes with diagram and procedure
http://www.jangro.com/a/2006/08/03/how-to-change-your-samsung-dlp-lamp-in-5-minutes

you will need to index the color wheel in order for it to have the correct tints

Replacing the color wheel can sometimes switch Red With Blue. If you remove the jumper it could fix the problem.

Here's an article on it's replacement.
http://www.jangro.com/a/2006/07/24/samsung-dlp-replace-color-wheel/

Here's a good article on the Color Wheel
http://www.jangro.com/a/2006/07/24/samsung-dlp-replace-color-wheel/

It says if your red and blue colors are reversed removing the jumper should fix the issue.

Most times color does not to be reset. If you have a very ugly green or blue picture, then you did not pull the jumper on the dm board. This jumper must be removed when a bering type color wheel has be replaced with a new airless bering color wheel.

I just had a service tech out and replaced the color wheel. now i have the same issue with the color...the people all look blue. He told me that now the the digital board is bad. It's the board were all of the connections go. I'm not convinced, as I remember reading something about color settings needing to be adjusted after color wheel replacement.