I have ann E63 code on my Electrolux dryer. THe vent pipe was somewhat clogged but now is cleaned.What do I do?
Posted on May 08, 2010
E63 is .....Heater to Earth Ground Heating
element or wiring defective Check
heater coils and connections for short circuits to the cabinet. Replace heater and/or wiring and retest... Regards
Posted on Dec 05, 2011
This happened to me because I had one garment in the dryer and had it set to normal heat. The lint trap was clean and no other issues contributing to overheating.
Solution: breaker
1. Open the door (it pops open in this condition anyway)
2. Wait 10-15 minutes for it to cool down.
3. Kill power for a few seconds (Pull plug or cycle breaker)
4. Run for 10-15 minutes with heat set to AIR ONLY.
This fixed my problem.
Posted on Mar 12, 2019
SOURCE: What is Electrolux Dryer Code
Error E63 in your Electrolux Dryer indicates that the temperature inside is too hot/overheating, to start with, check the vent and try to clean it. If still it's not resolved then the issue is with the thermal fuse going bad and needs to be replaced. It is mounted to the exhaust duct inside the back cover panel.
Posted on Jan 15, 2011
SOURCE: Electrolux dryer error code e61
There is a 'tech sheet' in the back pf the dryer. Unplug machine, Remove the access panel on the back to get to it. Reach in and it should be there. It will tell you how to do a button check. You have to enter a test mode through the buttons.
The E 61 is a stuck button.
Enter function test mode and perform key
stuck closed (active). (button) test to determine which button is at
fault. Carefully free the and perform the test
again. If button is free but the key struck code
still exists, replace electronic control.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c
Posted on Sep 25, 2009
I appreciate your post, Tim Davis!
From what you have described your Electrolux dryer is displaying an error code "E63". I understand that you have performed several tests on different electrical components within your dryer. I see you wanted to further test the wiring and I would recommend having a professional technician come out to perform a diagnosis. Since you have completed many tasks there are no instructions I was able to locate that provide further wire testing on your dryer. Best of luck! -Matt
Hello Curtis - Typically, error code E61 indicates a Heater Relay failure. At first the heater was grounded, and now possibly the heater relay. When the heater grounded it could have shorted the relay as well. Generally it is a good idea to have a professional take a look at it to get to the root cause. Cost of parts and technical expertise entailed in these types of replacements can be a bit tricky.
Hi boltonjamese...
E63 error code means that your dryer thinks the temperature is too hot.
If your unit is still under warranty they should fix it under warranty so I would highly recommend calling warranty to correct this issue as any problem to fix this will involve replacing a sensor or a control board.
Please take time to rate me
20,205 views
Usually answered in minutes!
What is Electrolux Dryer Code E63
×