My ilo 42" plasma which i have owned for about two years. A bad storm was going on outside, the lights is the house went off then back on. My TV then would not operate properly. It is only black and white and the v-chip is on and I can't turn off. can anybody help me? thanks
V-Chip Factory code is not 0000 as it say in there book they put that # in, 8202 is the real Factory v-chip code
For the color problem I punched the "System" button in lower left corner on my remote. Apparently this button is the Color System. After hitting it a couple of time it set to "Auto" mode and presto, the color was restored.
Yes I can help you all you have to do is turn off the set and wait for about 30 minutes and then turn your set back on the problem should be resolved sincerely ,unplug the set firsthave a nice day
766 views
Usually answered in minutes!
still does not work. Picture is still in black and white. the v-chip problem is fixed however-thankyou. My TV works full color when i run the cable through my DVD tuner. TV will be black and white when cable is ran directly to TV. can anyone help? thanks
My 42" turns B&W infrequently and varied quantity of vewing hrs. No set pattern, most not at all, but infrequently goes B&W. I unplug, wait 2 seconds, replug, turn on set. Wahlah! Color.
Has anyone received, seen, heard of, hoped for a recall or at least a Service Bullletin informing of the problem and parts or event to repair.
I'll keep looking. Good luck!!! :-)
HI,
I AM JESSICA PORRAS. I PURCHASED AN ILO PLASMA 42" T.V. FROM WALMART IN 2006. THE T.V. LASTED 1 YEAR AND POPPED A FUSE. THE SCREEN WENT BLACK, BUT VOICE IS STILL COMING THROUGH. I DID HAVE WARRANTY AND MY MONEY WAS RETURNED. I HAVE A QUESTION AS FAR AS THE BRAND 'ILO' GOES. CAN THE PARTS BE CROSSED WITH ANOTHER BRAND? SINCE THE FUSE HAS POPPED, WE HAVE REPLACED THE FUSE 3 TIMES, AND IT KEEPS POPPING THE FUSE. THE LAST 2 FUSES HAS BEEN A CERAMIC FUSE AND IT WILL BURN THEM. THERE IS A SHORT AND WE ARE WANTING TO CHANGE OUT THE TRANSFORMERS. IF I CAN HAVE A TECHNICIAN CALL ME @ 432-553-6784cell OR 800-880-2817work M-F 8-5PM CST. YOU CAN ALSO RESPOND BY E-MAIL.
THANK YOU,
JESSICA PORRAS
i hv an ilo pdp4210ea1 which intermittently fails to boot up its DTV processor. Gives a "no signal" rpt after churning 4 a bit. powering off/on sometimes gets it to go, but mostly not. good pix on analog and all other inputs. Hv ckd DTV antenna input, hv good signal levels from DTV stations here. Any ideas?
I have the same problem with only black and white and the v-chip. Any solutions?
I have experienced the same problem with my walmart purchased ilo pdp4210ea1 42inch plasma tv. A storm came through the area and the tv no longer displays a picture, there is sound. I am looking for suggestions to a solution. The tv is just about 1.5 years old. thanks
×