How do i fit a belt to hotpoint washing machine WF865

It should work with a cold water supply WF865 hotpoint if it has one connection on the back it is a cold fill machine all new machines are cold fill only hot fill has gone now. hope this helps.

Remove the rear panel of washer, and tilt washer forward away from you with someone to hold it steady.
Fit the belt round the motor pulley first and slowly feed it round the drum pulley turning the drum pulley at the same time,
It will be very tight, so watch your fingers.
It may seem to be too small, but persist with it, and it will go on.

It usually means that you need to replace the control module.

F08: Heater control or NTC (Thermistor) temperature sensor problem.

To get out of it you need to press start, the display should go daft. Press start again and the display should settle down. Now press the on/off button and the start button at the same time and hold them down for a few seconds until the display shows d-end or d-off.
Your machine should now work. hope this helps.

if you get a bit of washing up liquid and smaer on front edge of seal only and try if still same new interlock req

press start once
then press start again now hold on/off and cancel together for a few secs should no say d/off or something should work now

to take out of test mode you must turn it on while pressing the start/cancel and on buttons at the same time until dOFF appears.

you should be able to turn it off by holding it in for a while longer,5-10 seconds, unless the circuit board is at fault.

Connect a hot water supply