At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
MY RATE ISN'T RIGHT! I GIVE YOUR ADVICE AND SOLUTIONS TO MY PROBLEM 4 STARS!MY RATE ISN'T RIGHT! I GIVE YOUR ADVICE AND SOLUTIONS TO MY PROBLEM 4 STARS!
You can't post conmments that contain an email address.
A U4 is a fuser overtemperature.
You can hold down the "0" while powering the machine on. That will enter the machine into diagnnostics.
Next enter code 401, and press start, See of that clears the problem.
If it does. Remove the fiser and clean the buildup off the thermistor.
If it doesnt you will most likely have to replace the fuser.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
1. Check for paper on the fuser. Y remove paper N proceed to step 2 2. Check the installation of the fuser assembly, make sure it is securely installed. Y reinstall fuser N proceed to step 3 3. Remove the fuser. Check the conductivity of the contact points of the thermostat, are the contact points connected N replace the fuser
turn on power while holding down "0", press "stop/clear" and wait 30 seconds for optics to finish initializing, then enter "401" then "print", shut off machine, wait 10 seconds and turn back on. code should now be cleared.
A U-6 means the memory on the main board failed.
If the machine is old, the battery on the board is old and not holding the values in the machine.
Replace the main board will correct the problem.
Since it is in the middle deep in the machine you might need to have Xerox repair it for you if they still provide service to this model.
Good luck.
A U4 is a fuser overtemperature. You can hold down the "0" while powering the machine on. That will enter the machine into diagnnostics. Next enter code 401, and press start, See of that clears the problem. If it does. Remove the fuser and clean the buildup off the thermistor. If it doesnt you will most likely have to replace the fuser.
The fuser is not warming up.
On that machine under the web there is a thermal fuse on a white plastic mount, it has one screw through it.
It is most likely blown. Possibly caused by a jammed paper in the fuser.
That fusable link needs to be replaced.
YOU GUYS ARE THE BOMB! THANKS SO MUCH! I WILL TELL EVERYONE I KNOW ABOUT YOUR SITE!
THANKS A BUNCH!
MY RATE ISN'T RIGHT! I GIVE YOUR ADVICE AND SOLUTIONS TO MY PROBLEM 4 STARS!
×