Indicating cover open but the cover is closed and it's not switcing off

Basic Programming:

Open cover fully - Indicator will blink once on go out.
Press 3-5-7.
Press PROG - Indicator will blink once per second.
Enter PIN 1 (up to 8 digits)
Press PROG - Indicator will blink twice per second.
Close cover. Your keypad is now ready to be programmed to the garage door opener.


copy and paste

https://www.ohd.com/post1995-openers

The message indicates that the printer door or the cover located on the top is not closed properly, so you need to re-open the door or the printer cover and close it accurately.

GuruAid.com

The message indicates that the printer door or the cover located on the top is not closed properly, so you need to re-open the door or the printer cover and close it accurately.

GuruAid.com

it will be from cover sensor or Main board

This is not a good thing. Ford uses a computer called the GEM and that means General Electronics Module. It controls:

• Low Coolant Indicator On Cluster
• Brake Indicator on Cluster
• DRL - Control
• Wipers
• AutoLamps
• Rear Defrost
• Interior Lamps(dome)
• High Beam Indicator only (cluster)
• Low Coolant indicator
• Key-in Buzzer
• Seatbelt indicator only (Cluster)
• Trunk Pop Relay
• Power Locks
• Door Ajar Sensors
• Door Keyless entry pad
• Remote Keyless Entry
• One Touch Down (power window)
• Air Bag Tone
• Anti Theft (perimeter Alarm) (SEL, or SE(s) with mods)
• Lift gate ajar (wagon)
• Liftgate Pop
• Accessory Delay signal (accessory that work after engine off, prior to door ajar)
• Battery Saver Relay signal (accessory that work after engine off, 15 mins) Map lights, vanity mirrors

They are located behind the radio in the dash and they are $$$ about 600 USD.

TRY to open lens after switcing off and on it.or try after formatting..

Problem is simple, your system having sensor which indicating that cover is not closed. uncover it once and check sensor push button may be not connection well. recover casing and ensure its not loose.

Hi, the cover sensor may have gotten stuck. So, even though the cover is closed, it's still sensing that it's open. Here's a link on what you can do to remedy the problem. http://bit.ly/9UYvzL . Hope this helps

micro switc in door or soap build up on door. check consumer report web site to se if recall or not?

Step one: Remove the cartridges

1. Make sure that the product is turned on and then disconnect the USB cable from the back of the product.
2. Open the product cover and remove the cartridges.
3. Close the cover and wait for a message to insert the cartridges to appear on the control panel display.
4. Disconnect the power cord from the back of the product.
5. Disconnect the power cord from the wall outlet and wait for one minute.

Step two: Reinstall the cartridges

1. Reconnect the power cord to the wall, reconnect the other end of the power cord to the product, and then turn on the product if it is not already on.
2. Open the product cover and reinstall the cartridges.
3. Close the cover and print a calibration page, if prompted.
4. Print a self test report to make sure that the product can print.
5. Reconnect the USB cable between the product and the computer.
6. Try to print a document from an application on the computer.

This should work