How do i turn keypad lights on?

check the harness on the vehicle coming to the connector.

maybe you should try a master reset for that...and you click something from the settings

Hi

you could try doing this press the FN+F7 keys both at the same time leaving a few seconds
for it to either enable or disable and if this does not work then please press it again to put back to how it was



many thanks

Unfortunately this is your "check engine" light... your car is telling you that something is wrong. Many things can cause this to pop up and some of them are trivial so don't worry yet! The first thing you will want to do is get a reading of the code that the computer in your vehicle has stored. Advanced Auto and Auto Zone have a free service that will do this for you, all you have to do is drive there and ask them to scan your check engine light. They will grab their scan tool and ask you to lead them to your vehicle which they will turn to the ON position and plug into your vehicles diagnostics port. This will tell you what your car thinks is wrong and point you in the right direction or where to look. Sometimes it is as simple as having the system reset with the scan tool or simply removing and replacing your gas cap.

the exact same thing happened to me. i was in london and had low reception and that and i thought if i turned it off then back on it would be better again but now i just vibrates for a second shows the sony ericsson logo then goes black but the buttons keep lighting up and vuvrating but not turning on.
i dont know whats wrong but i think it has something to do with the battery so im going back to the shop i bought it from and ask them about it (lost reciept though :L) i might have to buy a new battery for it (everyone is saying something to do with an alein thin on the battey)

honestly i would replace the whole device because you dont know if the keypad is the only thing wrong with it something else may go wrong after replacing the keypad

From your main menu go into "Settings". Select.
Scroll down to number 5 "Light settings. Select.
Scroll down to number 3 "Keypad light". Select.
It will probably be set to "Night time" 05:00 PM.
Use your direction pad to change it to "Any time" Save.
The keypad backlight will be on all the time.

Hey everyone! I had the same problem, and I actually got it to work again! I hope these directions will help you get yours to work (from the manual):
1. Put the headset in pairing mode
• Make sure the headset is off.
• Press and hold the answer/end button until a solid blue light comes on. <== THIS IS VERY IMPORTANT! HOLD THE BUTTON UNTIL YOU SEE A SOLID NON-BLINKING LIGHT! (This is where I was going wrong with the directions.)
2. Set your Bluetooth phone to ‘discover’ the Jabra BT350
Follow your phone’s instruction guide. This usually involves going to a ‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and selecting the option to ‘discover’ or ‘add’ a Bluetooth device.
3. Your phone will find the Jabra BT350
Your phone then asks if you want to pair with it. Accept by pressing ‘Yes’ or ‘OK’ on the phone and confirm with the passkey or PIN = 0000 (4 zeros).

Good luck!

my keypad lights doesnt work how can i fix this help please!!

Everyone has to learn! Don't worry. Your NUM lock is one. You should see a light on the computer that looks like a little lock with a number in it (typically the number 9). If that's on, the number keypad in the center of your keyboard will act like a ten-key keypad that you see on the right side of large keyboards. Just hit the Num Lock button on the top right of your keyboard to turn it off.

Let us know how it turns out or if you have any more trouble. Keep learning! It's your best asset.