Lead vocal Only background vocals can be heard. How do I turn on lead vocals?

http://www.mackie.com/pdf/archive/cr1604_om.pdf

This is often caused when an earth wire touches a channel wire, check all your connections, especially those to the cartridge.

Note that you MUST use the special Karaoke disks to be able to remove the vocal... it will not do it for plain music CD's. Those devices that CLAIM to remove vocals often do so poorly... they do it by subtracting the left and right channels which ASSUMES the lead vocal is centered between the channels... Those methods don't work very well...

some of them require red , white, blue, green, an yellow audio jacks. make sure you have all the input plugs. or eles the tv will not use plugs it doesnt have.

Try changing from surround sound to normal

please rate my help++++Thanks for using FIXYA

That sounds more like a polarity, or phase problem. Make sure your speakers are hooked up correctly, with the correct colors going to (+) positive, and (-) negative. Make sure your rca connection are correct, and that every connection has a left and a right. No stereo-to-mono adapters.

Is setting to "vocal" an eq selection, or a "dolby" stereo selection?

Are you using a dolby surround stereo receiver with left, right, center, rear, etc.?? If so, try turning off any effects, or anything that would send signal to the center speaker.

Lastly, depending on what the source of your music is, it is possible if your connections or receiver settings are not correct...that the music upon playback will be out of polarity, meaning the vocal portion will cancel out. Combining left and right signal together can sometimes do this as well.

how can I started playing the magic sing I dont have my instruction manual, I tried to hook into the tv but it doesnt work

my aguen player is frezzing and i turn it on and the screen saver stays there and if i charge it, and turn it on it works but then when you want to turn it off the screen thing stays there and nothing happens you can't turn it off or on.

Hi im joe,
Regarding your concern the ET 3000 magic sing does not have background vocals at all. The manufacturer design the magic sing for sing along purposes only but they are now improving there future products to have that feature with background vocals.

hi there..if there is video and background audio coming out from the TV, and no voice recognition from the mic- then mic is the problem. I believed the problem is the "voice coil". This is a part that can be replaced- you can contact me and we can repair that.

two ways to check
remove the mic ball
the part which the mic ball is is covering is the voice coil.
try holding both terminals (black and white wire)- if there is feedback sound- it is open and need to be replaced
try using your tester- test the impedance- there should be 500- 600 ohms reading

([email protected] or customerservice @magicmic.com)