If i want to go camping but dont know the address how do i plot a rout to get there?

Create a route, save it with a name then load it from your archive ( you can use any saved routes ) the chart will show the route and your current boat location

Software needs to be reinstalled and this is not easy at all, get help from previous owner, the reason why he sold it must be the problem you are facing now - SOFTWARE IS SCRAMBLED.Good luck

One of the statistical plots is still active and you must turn it OFF.

1. Press [2nd][Y=] to open the (STAT PLOT) configuration screen.
2. Press [4:PlotsOFF]
3. The PlotsOff Command echoes on main calculator screen.
4. Press [ENTER] to run command.
5. Go back to [Y=] editor to edit the functions if necessary, then press [GRAPH].

Hello,

The 60 CSX dosent support custom maps but if you are looking to plan a route or plot waypoints the easiest way is to acquire a copy of Garmins TOPO disks and do all of this on the PC. You can also do this on the unit using " Mark Waypoint".

Hope this helps!

hi, you didnt mention what model gps you have, but most gps simulation do the same thing. if you have the simulation activated (some models are on by default, others are off by default) once you put in an address for the gps to guide you, the gps (if in simulation mode) will show you the coarse you will be taken, before you start out.

so if your in NY and plot a coarse for California, it will show you moving along the plotted coarse...thats going to take quite a while to view since the simulation will move along at what ever the posted speed limit is along the route, so its kinda like watching grass grow unless it doesn't take much to amuse the person watching the simulation. it is quite handy in that it allows you to view turns and intersections ect ect ect before you ever get to them.

hope this makes sense...let me know if i need to explain it better, but if you turn on the simulation mode then enter an address, you'll see what i mean.


bill

I assume it works ok in the U.S., and most of Mexico. Assuming that, it will be one of two things. 1. Either the locations are not programmed into their software, or you need an update to your GPS. My guess is that they haven't updated yet. I would message Tom Tom to let them know your concerns- sometimes the squeaky wheel gets the grease. Good luck, know it's aggravating.

Hello,
Some old junk is in memory. Reset the memory to defaults and everything will be fine. It is a good practice to clear memory before a new calculation.
To reset memory
Press [2nd][MEM][7:Reset][1:All ram][2:Reset] [EMTER] . Clear screen and enter the functions you want to graph.
Hope it helps.

on a ti you need to press the y= button and put in individual points that will be plotted after you graph

does it include the map for North America and Canada?
you may have to reload it
try using shortest route