I was online with my new 15 in. dell studio laptop, and using a belkin N router. everything worked well until it stopped all internet connection. though my desk top still has its connection to the internet. i have tried all remedies that were recommended, nothing works, as well as the reset button on router, what do i do now ?

The printer's IP address most likely needs to be changed.
Check the Belkin's IP address range (it maybe 192.168.2.***) and configure the printer's IP address accordingly.

do u want answer call me 9966295175

Its not necessary to purchase a new router. Nintendo DS supports WEP encryption. You wont be able to connect if the encryption on the router is WPA. Your computer can connect on both WPA and WEP so what i suggest is for you to access the router page then check the wireless settings then change the encryption to WEP so that your Laptop and DS can connect at the same time. To access your router check the manual for the username and password


Thanks for using Fixya.

And what throughput speed of the Internet at you?
http://conditioner2009.bravehost.com/

get rid of rthe Dell; router and never buy dell anything Dell is made by DILLS use a proven brand of router

have you restarted the router? if so, then see if Belkin offers a firmware update. You will need to connect with a cable to do the update.

The procedure is 1st. to connect the LAN cable to the router (not to the LAN port marked WAN) and use the browser to configure the Belkin router for the wireless settings.
In the wireless setup change the SSID from the default SSID to what you like., set up encryption (if your wireless card supports WAP then use WAP encryption, if not use WEP 128bit)
Also change the administrator password (write it down and put it in a safe place).
you can disconnect the LAN cable from the computer and router.
If you had not installed the wireless driver for you wireless card, do so now.
Connect the LAN cable to the WAN port on the router and the other end to the Hughesnet.
Now configure the wireless card with the SSID and the encryption that was set on the router.
If all goes well you should see your router and get on to the Internet.
Get back to me with error messages if you have problems.

If you have left your router open, you may have been hacked.
Ring Belkin support to make your router more secure