Printing oddly this printer has been working fine for about a year and half or so now all of the sudden. In the last 2-3 weeks it started doing th following. -It prints the job, but prints the even pages first -it then prints the odd pages upside down.

i aint too sure if its the same but i had an epson printer with the same problem last year it would print half a page spit out and then print the same half a page again and just stuck in a loop even on printing disks it did the same i found out after by speaking to a printer specialist it was the printers eeprom which is the printers memory bank that was failing and nothing can be done with it

have you checked the wire that goes from alternator to the battery ,and see how many volts are going back to the battery. it maybe grounding off

Sounds faulty to me (especially if it has been working fine for the last few years), i'd get it replaced, some of the new TiVo boxes are insanely good, and well worth checking out despite their also insane prices.

Thanks,
Moza805

If you've only bought it 2 months ago it will still be under warranty.

Try to clean the contacts at the cartridge and the printer

your printer open just cling and your head problem

several reasons may cause this problem.
-On Tec printers, the height of the labels must be the most precise possible. You must include the gap height in the command
{D0350,1000,0320|} for la label size 100 mm and 32 mm high and 3 mm interval. If this information is missing, the printer may work correctly for some time and suddenly you'll have your phenomenon.
- You may have a label stuck under the sensor.
- You may need to recallibate your sensors.
- the correct sensor is not selected

Thanks but after reading everyones elses problems I threw my kodak easyshare printer dock in the bin, (had to keep one as it is my battery charger for camera also, another downside) then went and bought a canon mx860. so far works lovely, just havent got water proof pics anymore.

Yes, I belive it's your ink

The black printing usualy occurs when there is a faillure in the light, since your light is working fine, there may be a problem in the imaging device inside(camera) or the reflector. There is nothing wrong with the cartridge.