My garmin gose not move when we move - Garmin nuvi 250W GPS Receiver

Sounds like a bad float or weak gauge.you can always use the miles trip to predict how much fuel you have left in cases like these the trip can be your best friend.have someone experienced change the float in the tank then if not float change gauge but like i said someone that knows what they are doing if not they can mess the entire dash up and short alot more than you would think out so try float or gauge if it has over 150k miles its probably the float.

if you are talking about a sound card it gose in a pci slot it is white slot put a screw in the top of it so it will not move ok

NOT TO MUCH TO REPLACE BUT COULD MOVE ARM WHERE CABLE GOSE TO GET IT TO RUN

Your tranny is going out. I just had that happen with my 88 Sierra and now it works after it was rebuilt.

thermostate housing?

Reset the unit by sliding the power button the the left and hold it at that position for 15 seconds, then release.

It is the main board failure, because Insignia TV has no error blink design.

It sounds like the thermostat is stuck open.

The garmin works off of a GPS signal. If you are not moving, the GPS signal doesn't pick up any movement . . . .because you are not really moving. m Therefore, the speed and distance is nil.

Well what is your PIN number? You had to have set it for it to ask tou for a PIN. If you don't remember your PIN go to the location where you set it and it won't ask you for the PIN. From there you can remove the PIN or change it to another number.

- Jim