My ge profile sca1000dbb-03 advantium oven just quit on me one night. No lights, clock, vent, no power at all. Checked all circuit brakers, fuses and power supply. What else could it be?

Barbara I highly recommend contacting GE directly at 1-800-433-2682 or go to www.geappliances.com Marcus

There may be grease or moisture in the controller, which needs to be taken apart and checked. I do that kind of work.

Fee free to e-mail me at [email protected] with your full model number as shown on the tag in or on the oven, and your detailed symptoms for free advice.

Unplug the microwave oven for 60 seconds to reset microprocessor, hopefully this will cure the problem.

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Basic Microwave Oven TroubleshootingTips

heatman101//

It sounds like the magnetron may have either failed or is not being supplied with the extremely high voltage required to run it.
Make sure the !!!!capacitor is discharged!!!!! before attempting any sort of repair.
Check the door interlock switches first then the high voltage diode with either an AVO model 8 on high resistance range for short circuit, the capacitor can fail and go short circuit, the feed fuse on the primary of the high voltage transformer and then finally, the magnetron is best checked by substitution.
Hope that helps.

Most likely a blown fuse inside the MW. It will be on the control board or on the incoming power line inside the cabinet.

Select the "Options" menu and adjust the clock display settings if the display is blank. Set the clock if the oven won't start. The clock must be set for the oven to work properly, as oven programming is dependent on the clock.

Close the door tightly if the oven won't start. The oven won't start if the door isn't closed. You can identify from the lights whether the oven failing to start is related to the door or to the power supply. If the control panel is illuminated and interior lights are on when you open the oven door, you can be sure the oven is receiving power and any starting problems are due to the door not being closed tightly.

Press and hold the "Clear/Off" button if the oven performs strangely. Be sure to hold it for a few seconds. This will reset the GE Advantium.
But as you mentioned that there is /was a loud noise this is a indication of the unit make any usual noise (groaning, gurgling, etc.?) or was / is it either louder or quieter than normal?It may be as simple as the top door switch or its mount or it may be a bad magnetron or shorted diode.
For manual of the oven.please click the link below:--

http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=49-40577-1.pdf

-------------

Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

You can find the replacement fuses at the local Radio Shack.

My PVM2070 Spacemaker Microwave quit working & its DEAD. I checked circuit braker, unplugged unit, checked power is ok, open/shut door, pushed very sensor buttons; its DEAD. Help??

The problem with my Advantium was the fuse inside the microwave.Thanks to all of your fixya emailers ,I was able to change the fuse myself.I would recommend your site to all as you were a great help to me. Thank you, wlpasko.