Battery hello ive tried to change the battery myself ,big mistake ,when i tried to soder the wire back on part of the bord were you soder wire came off ,soder will not stick any more ,is my phone scrap now ,thanks.

Check the wiring boss you have shorted out the small thin wire to the starter motor somewhere along the line and i cannot see your mistake from alicante spain .What you done is a classic which even the mighty god of car ---myself in person -- has done the same thing ,i have also put petrol in a diesel car ,forgot to tighten wheel nuts and put a clutch plate in back to front --come on you learn by mistakes and that is to turn the dammed phone off or have a nice little dolly bird in a nice uniform with a short skirt to answer the phone so your not disturbed ,brings in a lot of work as well . what a bad person i am,

Hello Madam / Sir,

I made a big mistake. i wanted to my friends say something about me and i forgot to change the message. so you deleted my account.

i am very very sorry because of it. Can you active my account again please?

That is the warning "Your account has been disabled by an administrator. If you have any questions or concerns, you can visit our FAQ page here."

What can i do to be activated my account again?

Regards...

i cant spel good but deall with it

okay thers a few thing that can be wong with it. i can only say thisd. if it derty you should depending on how much dert on it you a cleen it with a spray bottle or take the keys of it and cleen it out then replace the keys back on it.... mack sher you rember ther order. prob 2 is bad cord. youll need a broken key bord and a sodering eye-ern. you the tack apart you bord and then photo grafe the bare cord you should se som clored cors that go into you bord chip photo that. ockay remove bothe the cords frome you two key bords then replace that cord to you bord ther have fun......

i dont want to make u feel like u dont know what ur doing, cuz trust me ive overlooked stuff that i wanted to hit myself in the head with a ball pin hammer myself more times than i can count. go look at all the wiring at the rotor assembly and make sure there isnt a wire that is cut or smashed or exposed. im sure u have already done so. but man ive over looked some stupid sh$t over the yrs. one yr building my hotrod i switched two plug wires and didnt catch the mistake until i had enough fuel in the header collecter to ignite and sound like i blew the whole garage up. so i put a new header in. fixed my ******* mistake and for days couldnt figure why my whole left bank was misfiring!!. so 2:30 am i cant sleep i go to garage i didnt turn on lights. i just started it up. and crawled under it. the lightning storm was beautiful!!! :) i didnt wrap my new header!! lesson learned. good luck brother

Youre right. Big mistake. You can try to contact Sportline at the following link
http://www.sportline.com/contact.php
Good luck

See this site for piecing together. Has pictures. Pass along.

http://sunsthomasandfriends.weebly.com/big-loader-info-and-repair.html

This does not sound like a problem with your rewire job as it would not cause the computer to react in such a way. Try removing the battery and resetting the computer. If it is still not working your computer head has likely gone bad.

Hope this helps!

disconnect all and reconnct it.something jammed .may be *********** bord circuit is ground.
disconnect hdd ram then try.
to reattch one by one.
try with only smps ,mother bord and ram.
also check processor sitted correctly.

Here is a site that has several videos on how to relamp. Its pretty informative. http://www.dlplampguide.com/tlpl78.html

DONT try to change a watch battery yourself unless you have crystal press to close it and thats if the case back pops off...if it screws on then you need a case wrench to open and close it! Better to seek out a local watch repair business and avoid Walmart! :-P They arent trained to repair watches...Ive fixed a lot of their mistakes!