Have Smart NAVI DOTN300 put new battery in .does not load up.

SOLVED: My konka smart tv is stuck on smart tv loading ...

www.fixya.com > Forum > Televison & Video > Konka

May 27, 2018 - my konka smart tv is stuck on smart tv loading doesnt go further - Televison & Video. ... check the site linked here. Pull up older posts. ... My TV Konka LED TV KDL55XS712AN is not starting and saying: LOADING... Corrupted ...

How to perform a Forced Factory Reset on an Android TV ...

www.youtube.com > watch
Jun 8, 2017 - Up next · Sony Smart TV: How to HARD FACTORY RESET without Remote (Use Buttons on TV) · How To Run Through A Power Reset On Your TV.

Konka LED TV KDL55S712AN has refused to start and is ...

www.justanswer.com > ... > Smart TV Problems

Sep 2, 2016 - Konka LED TV KDL55S712AN has refused to start and is staying in the screen on" Smart TV loading..." ... Then on the actual TV, hold the power button for 60 seconds then release. Then wait 10 minutes, connect the power again to the TV, turn it on and tell me please if it is now operating correctly. 1 answer

Android Stuck On Boot Screen and How To Fix It ' Wirefly

www.wirefly.com > guides > android-stuck-on-boot-scr...

Restart The Device. This is the first step in troubleshooting an Android device that won't boot past the startup screen. If this has not been done, it ...

..

Potential Hard Drive failure, (Hard drive s.m.a.r.t. beep) or if MB beep it's chassis intrusion..

1. Remove battery + disconnect power
2. Hold down power button for 20 seconds
3. connect power only (no battery)
4. Turn computer on.


If the beeps stopped.. get a new battery, if the beeps continue..
ABANDON SHIP!

Not sure, but try loading Safe Mode by pressing F8 during boot and lowering screen resolution. In Safe Mode you can even run System Restore. It load to a previous date that you choose.

Do a system restore/recovery.Skip the repair.

need to power on and boot with hiran boot cd and check the hard driver bad sectors to run check disk

Yes, It Will Install And It Will Load Default Drivers, You Might Need To Still Get A Few Drivers That Vista Doesn't Recognise...But Again, It Will Still Fully Install...

I've reads post here suggesting disconnecting the battery for one hour. Couldn't hurt to try it.

Also try ejecting the Navi Disk, inspecting it for any damage, wait a few minutes and reinserting. The disk contains not only the navigation Database, but also part of the operating system.

DO NOT TRY INSERTING A OLDER NAVI DISK OR ONE FROM ANOTHER VEHICLE, THAT COULD DESTROY THE NAVI UNIT!!

If you need a new Honda Navi Disk, order it direct at https://www.hondanavi.com/Hondadvdsales/naviorder.php

Good Luck

Disconnect the a/c power. Leave on until battery drains completely.Then plug in and allow battery to fully charge before starting.Should work then.RICHARDM69

Regarding the Bush DVR3004 and the 'Smartnavi' screen, a workaround is to repeatedly press the record button on the remote while the "DISC LOADING" screen is displayed.

let the ups be turned on just charging the batteries, u can have the voltage but the batteries still not fully charged. good luck