Wont spin cycle at full speed

Pretty much the same cause for all washers, just not exactly the same one as yours. Probably have to lean it over carefully to get under it to get to the coupler. https://youtu.be/_fHoAjOmHDU hope this helps

many machine spin a full tub as they are pumping the water out
this helps to even out the washing load and reduce the unbalance situation
when the water is removed , the machine progresses the program to a high speed spin
call a technician as there may be a problem in the program board

Most likely the timer needs relaced.

The machine fills but won't agitate. It does spin out at the end cycle. New to the stacked units.

check the belt it could be loose

Hi,
Here are a couple of tips that I wrote to help people that are having problems with the washing machine not filling...

Washing Machine Problems No Water
http://www.fixya.com/support/r3880845-washing_machine_problems_no_water

Washing Machine Fix Washing Machine No Water
http://www.fixya.com/support/r3880533-washing_machine_fix_washing_machine_no

heatman101

You will need to replace the switch I am afraid. If I had your Model # I could get you the part # . If you would like to order a swtich, I can give you my web site address

I would appreciate if you would rate my prfomance here because I am new to this site. Any feed back on how I am doing would be helpful.
Thanks
Vic

sounds like your spin brake is not releasing when the spin starts

We have had that happen too. You will need to take out what ever has blocked the valve on the drain. Ours was a bobby pin! My model is a bit different but if you follow the drain hose underneath you can find it. Remember you are dealing with lots of water. I think I scooped out the water first and have some towels ready. Or hire somebody to do it for you. I hope that helps.

check the belt, pulley, & idler pulley assy.