Red error message pops up while watching tv

time to take it in for a proper diasgnosis and then to decide if to fix or not

Lamp inside TV is broken and requires replacement. Pop sound was its breaking sound.
Lamp replacement procedure is written in user manual, pretty easy.
Please buy Sony original lamp for TV safety and avoid aftermarket/ cheap lamp.
Let me know if you need to download user manual copy.
Thanks.

Please intimate exact model of your Sony TV to find out reason of no power up.

Hello,

First of all Check Flash focus is working or not?(Flash focus should finish 1 full cycle)
If Flash focus not working you will have a error code in your screen.
If any error message or wont compelte full cycle you have problem with convergence amplifier IC
It could be one of your IC bad along with Couple of small Value resistor.

Dont Forget to Rate!!

Good Luck
Dals123

Have you tried with a new scart or htm lead?

If you watch how many times the light flashes and then relay that to your local authorized sony repair centre they will tell you what is likely wrong with the TV. Have you unplugged, left for a couple of minutes and re-plugged?

My plasma display the "error message condition 1" and red flashing light start blinking and TV screen shut down. Who can halp me to fix the problem??

When the lamp fails in this unit, often the thermal fuse opens. The error code is 6 blinks. To replace this part requires a great deal of deal of disassembly.

Remove front speaker grill and access panel......
Turn red screen control down a little...
Cause may be bad CRT.......................................T.

i think it is a magenatic effect called degaussing problem. please remove anything very near to it which has got magnet like speaker headphone etc. call tech to gegauss it. it is hardly 5 minutes job. please do not change the angle while watching tv. your tv seems to be 100% ok. good luck.