Maytag washer model number mav6057AWW Serial Number: 10542522WY
My Maytag would spin on the rinse cycle but not on the rinse cycle. I turned the inside tub until it would turn anymore and that seemed to work for a while. Then, the tub banged violently against the side. I took the back panel off just to take a look around. I moved the exterior tub around to see if one of the springs were off or loose. Then I just plugged it back in to test it. Lo and behold, it worked. The tub span well with no banging at all. I pretty happy about that, but I suspect it's just a temporary fix.
What do your think is the problem?
My maytag washer wont spin the water out during it's final spin on the heavy cycle, but if I move the button to another cycle like delicate or medium it will spin out the water during that final spin. there is no hose blockage, the water does pump out during another setting just not on the long heavy cycle. Model lat8714ae........ao17894ko...any ideas anyone????
Chances are you had a blockage in the pump and it tried to spin with the water still in the drum. check the bottom hose and filter for blockages so it does not occur again.
1,819 views
Usually answered in minutes!
My Front loader Neptune went into an imbalance alert and would not spin out the clothes even though the was not a big load and it had already gone through several loads. I took the clothes out of the tub and tried the spin cycle and the same alert came up. I waited a couple of hours with the machine off and tried the spin cycle again and this time it worked with out throwing out an imbalance alert. I suspect that the imbalance sensor is not working correctly.
drum bangs on spin cycle
My machine (Kenmore 800) does the same damn thing and its bran new. Seems the tub is too easy to rock and the spin is not symmetrical.
×