Cannot find solution to how to replace paper for the Sharp UX-108 Fax machine

First make sure the original document is loaded with the correct side facing down. If not the problem try taking out the roll paper and reload it with the other side of the paper facing up

Click on the link below to view the Sharp UX 108 user manual. Inside this manual it will show you how to change the language:
http://www.scribd.com/doc/31544424/Sharp-UX-108-UX-178-UX-188-User-Guide

You haave a bad SCANNER Block, very expensive.

http://www.usersmanualguide.com/sharp/faxes/ux-108_178_188
That will have what you are looking for.  Please dont forget to rate!

Problem is most likely caused by a worn paper pick roller. It would be more expensive to repair this fax than to just replace it.

On inside of machine it states how to:
1. Place new paper roll on the left hub while pushing it in, lowering the roll into the compartment making sure it is inserted onto the right hub.
2. Pass the leading edge of the paper through the paper cutter guide and the cutter.
3. Remove any slack in the paper.
4. Close the cover. The paper will feed out automatically.

The paper rolls over top front to back.

first the paper is rolled over the top and then roll it slowly under untill you can pull it out by hand. At this point you can close it and it will automatically start to feed.

I need the operation manual

Just put the thermal paper(paper roll) inside the machine and the SHINNY side of that thermal paper would be on the Top side where the thermal unit is place or vice versa.

http://www.usersmanualguide.com/faxes/sharp/ux-108+178+188/

or just google "UX-108 user"