Question about Onkyo TX-SR501 Receiver

1 Answer

My Onkyo HT-R510 will shut down after several

My Onkyo HT-R510 surround sound receiver will shut down after several hours of operation and the red standby light flashes. What could be causing this? This is a valed product!!!

Posted by mhiatt136 on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Might be over heating. Make sure you don't have anything sitting directly on top of it. I even put a little fan blowing outward at the back of my system to keep it cool.

Posted on Feb 13, 2010

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My onkyo HT RC330 will not power up at all. Have had problems past couple of months with starting it but if you played around with swith it would start. Now nothing.


Try resetting the AV receiver To reset the AV receiver to its factory defaults, turn it on and, while holding down VCR/DVR, press 8 ON/STANDBY. "Clear" will appear on the display and the AV receiver will enter Standby mode.

It is possible that the protection circuitry has been activated. Remove the power cord from the wall.. Disconnect all speaker cables and input sources, and then leave the AV receiver with its power cord disconnected for 1 hour. After that, reconnect only the power cord and set the volume to maximum. If the AV receiver stays on, set then the volume to minimum, disconnect the power cord, and reconnect your speakers and input sources. If the AV receiver turns off when you set the volume to maximum, disconnect the power cord, and contact your dealer.

If the standby light is lit it and the unit will not boot it is most likely that the protection circuit has been activated. If there is no standby light then check the fuses. These units check that the power supplies are operating near specification. If a capacitor or resistor in the circuit, or a broken solder connection the unit will shut down. Because of the temperature the thermal cycling around the power supplies a broken solder joint can occur. This will make for an intermittent operation.

Hope this helps.
26289825-owoa52fq3dbvw0lom3ojbzgr-3-0.jpg Failed resistor or capacitor


26289825-owoa52fq3dbvw0lom3ojbzgr-3-2.jpg

26289825-owoa52fq3dbvw0lom3ojbzgr-3-5.jpg

Sep 23, 2016 | Onkyo Ht-rc330 5.1-channel Home Theater...

1 Answer

Want to control my HT-R510 with my TV remote. Need Onkyo code to control this HT-R510


You should indicate you remote.
In any case, if code is not in your remote you should follow indications for No code
If you don't have a manual, look for one using google,and terms manual, make and model of your remote

Aug 26, 2015 | Onkyo Audio Players & Recorders

1 Answer

Onkyo ht-rc180 standby light blinks will not start.i tryed factory reset, still blinks


The amp protection circuit has been activated. Remove the power cord from the wall outlet immediately. Disconnect all speaker cables and input sources, and leave the AV receiver with its power cord disconnected for 1 hour. After that, reconnect the power cord and reconnect an input and a pair of speaker wires onto the unit. If the receiver still does not turn on than you will have to bring it in for service. Turn up the volume and if the receiver doesn't shut down, power off the receiver and add another pair of speakers. Power up the unit again and turn up the volume. If it doesn't shut down, power off the unit again. Now connect all your input sources and turn on your receiver. If the unit shuts down again, your unit will need to be further serviced at an authorized Onkyo service center.

Sep 24, 2014 | Onkyo Ht-Rc180 7.2-Channel A/V Surround...

1 Answer

Onkyo HT-R510 left side speaker garbled


Out put transister could be fried ,Or the speaker is blowin,

Nov 29, 2012 | Onkyo Ht-r510 600w 6.1 Dts Home Theatre...

1 Answer

Onkyo ht-r530 subwoofer stopped working


Turn the out put leval down on your sub, End the reciever, I was turn up to high,End that will cause it to cut out.

Oct 20, 2012 | Onkyo Ht R530 Receiver 7.1 Surround Sound...

1 Answer

I CAN'T GET MY ONKYO HT-R340 AV RECEIVER TO TURN ON, IT WAS WORKING FINE , STANDBY LIGHT IS ON BUT DOES NOT TURN ON. ANY SUGGESTIONS?


I have the same problem during years, I have the same av rereiver and the device switchOff (even in standby). The red led is not visible. During several hours, rare time minutes it is blocked.
I sent it, the last year to the official technical service and they said me that nothing matter with it!!!

The worst buy made by me, goodluck, if you have solution I will be pleasure of your information

Juan Luis Santiago

Sep 09, 2010 | Onkyo HTR500 Receiver

1 Answer

Selecting phono preamp for Onkyo HT-R510


The magnetic cartridge preamp should work with the turntable, as presumably it will have a magnetic cartridge in it. The only reason that the amp states "magnetic" is that some very old turntables have ceramic cartridges which should not be connected to that terminal. Even if the turntable had a "ceramic" it could be replaced with a magnetic one!

Mar 21, 2010 | Onkyo HT510 Receiver

3 Answers

Onkyo HT-R501 7.1 reciever issues


i have the same problem with a onkyo tx ds494

Jan 05, 2008 | Onkyo TX-SR605 Receiver

Not finding what you are looking for?
Onkyo TX-SR501 Receiver Logo

1,166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Onkyo Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5700 Answers

The Knight
The Knight

Level 3 Expert

76416 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you an Onkyo Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...