Rear projection guns not alligned red and blue outlines on images

Hi,
Please run the convergence feature on your TV. Its giving you double image because the red, green, and blue guns are dis aligned. By running convergence it will realign the guns properly. You need to run the convergence feature at least once a week. Please note this is only for CRT rear projection TV's and I assumed it was. If it is an LCD rear projection, then there's nothing you can do to fix such thing, but call a repair person. But if doing the convergence doesn't fix the problem, you need to call a repair person. But I hope you won't have to refer to the manual on how to go about it
Good luck!

the tv guns are missalligned.This tv relies on three diferent guns red green and blue.If these guns are corectly alligned they can make every coller in the spectrum

Assuming that your TV is a rear-projection TV, then it sounds like the separate red, green & blue tubes aren't set correctly.

Each tube needs to be alligned exactly to produce the image on the screen. If any of the 3 are mis-alligned then the effect you describe is caused.

Somewhere in the menu settings, will be an option to set the Convergence. This option will allow you to set the allignment of all three tubes.

Older sets do not have this option, and need to be adjusted via controls on the main PCB.

Unit will require the 2 STK392-110 convergence amps to be replaced along with a couple of low ohm resistors.

i think you need a new convergence board they rin from about 88.00 to about 140.00

somewhere in the tv menu there is a place to make video adjustments. one should be for aligning the color guns. one is for red and the other two are green and blue. it will give you a cross in the center of the screen. it should also give you prompts to adjust the lines for centering and to save changes. this happens eventually on all rear projection tv sets.

sounds like the red convergence Ic is weak ready to go out. try replacing the ICs around 10.00 do the blue as well as that will be next.

the fluid in the bule gun is cloudy therefor the image you need to replace the fluid (coolant) inside the gun. the fluid is toxic (eytholene glycol). so have a tech do this for you. the repair may cost $ 325.00 or so.

well i think its an circuit prob if theres any circuit break on the pcb panel or panel connector would b loose

The Samsung has bad convergence IC's most likly. This should be repair ONLY by a trained technician as a TV set is not a place to experiment or tinker with because of the extremly high voltage inside. This repair should cost you in the range of 250 to 400 bucks . Good Luck