I dont have the disc, or the wire to go with it

if the eject does not work and turning it off and on dont work.. it calls for a manual extraction..this needs done with a small diameter wire to the center of the disc..hook it and gently pull out since the recorded material is on the bottom.. put the wire in so as not to scratch the disc so it can be played in another unit..

Is the sound working fine for the radio? If so, are you using an amplifier? If you are using an amplifier make sure you are using the blue/white wire (amplifier remote turn on) instead of the blue wire (power antenna remote turn on). The blue wire turns off when leaving tuner mode.

Check all the wiring again. In this case you need a good grounding source to be supplied to the system. Check the brown wire, which is negative and must be grounded. If you are sure that the wiring is perfectly OK, then call the dealer and tell him the problem, if needed to change it, do it so.

Laser burn, looks like complete or partial circular scratches around your disc, also known as “the ring of death”. This occurs to discs when the games console has been moved whilst playing, from an upright to a horizontal position or vice versa or simply knocked against or the wires may have been just tripped upon. Discs are then impaired by a ring of laser burn, which is a circular scratch into the disc. Some home remedies may help with very light scratches on some discs but professional disc repair services is normally rerquired to restore disc laser burn damage back to "As Good As New Condition".

For further help on laser burn discs repairs or to get Xbox & Xbox 360 discs repaired professionally visit:

www.discREPAIR.ie

You can send your discs off to this Disc Repair Service and the discs shall be sent back as good as new.

insert the recovery disc or the drivers disc that came with your desktop. reinstall the Card reader and USB 2.0. have made any changes recently in the wirings inside or any new IDE/ SATA devices? this could also be due to incorrect wirings...

there is a slot behind the screen when you push open the screen should drop down. put the cd into that slot when you do the screen will go back up. push open again the screen will drop and your cd will eject automatically.

You have the wrong wire hooked up to turn on your amplifire. You used the blue wire but need to use the Blue/White wire!! That is an amp turn on wire Thje blue one is for a power antenna and goes dead when you put in a disc. The tweeters play because they are hooked direct to your Jensen. You'll be jamming in no time.

Larry T
Winona Lae

http://www.cybersoundsaudio.com/cybersounds/vehiclepics.html IN

Hi, It is simple power speaker unit and does not need any software to work.
Please check connections of speakers, hook its line wire in line-out of of PC and make sure PC have correct sound drivers installed. 

If your spindle has stopped spinning, it will most likely be 1 of 2 problems. Either your spindle motor has burnt up, or even though it is very unlike, a lead wire that supplies the power to the spindle has became disconnected. Now, if the case it the burnt up spindle motor, there are hundreds of motors for every kind of PS on, of course, E-Bay. If the problem is for some reason, a soldered wire has broken from the motor. It is very simple to re-attach the lead with a quick touch from a soldering iron. I hope this has helped.

I too do not understand how to check the motor or change the wire