Sensor error on hp 2600 printer please - HP Color LaserJet 2600n Printer

54.06

Error message

54.06

Description

Color density sensor error

Action

1. Power cycle the printer.
2. Calibrate the printer. Click here to view the document "HP Color LaserJet 2600n - Calibrating the printer" available on the HP Web site at (http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00314525).
3. Change the Print Density settings through the HP Toolbox. Click here to view the document " HP Color LaserJet 2600n Printer - Change Device Print Settings in HP Toolbox" available on the HP Web site at (http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00310627).
4. If the problem continues, contact HP Customer Support Center for technical assistance athttp://www.hp.com/support/clj2600n or see the flyer that came in the printer box for additional contact information.

Hello,

Please download and run the HP Print and Scan Doctor from www.hp.com/go/tools

cartridge may be jam or damage

Yellow scanner error. You will need a tech to replace the Scanner unit.

DC Controller error.
Turn printer off for 60 seconds. If it's plugged into a surge protector, plug the printer into a wall outlet. Power it on. If it works - good. If not check the firmware version and upgrade it if needed. Other wise replace the DC Controller.

The fuser is the part that melts the toner onto the page, the error is thrown by a sensor which monitors the fuser, powering off unplugging and waiting for the fuser to cool (about 25 minutes, dont test it by touching it) before turning back on the printer will fully reset the sensor and may get you going again however this wont fix a fault with the fuser. However the fuser is a consumable which means they can be purchased and fitted by the end user (Not cheap parts), I always recommend that you users buy from the manufacture as they will stand over any item they sell you plus advise on instalation and problems however check prices on-line first and make your own call

http://printertechsdotcom.stores.yahoo.net/hpcola26fune.html

Check the expiration date on the cartridge, you may just need a new one. The date is printed on the side of the cartridge. They also just go bad sometimes.

Door open could be either the front door, or the top cover. Both have an actuator for the switch.. A pinched wire could also be your problem.
That failure to feed out might be your feed rollers and separation pads .. need cleaning.
especially since you've had to tear down.
I clean them with plain water, and blow them dry.

I hope this will solve your issue.
Good Luck.

If my solution proves useful please accept it.

Regards
Arjun

I don't believe Vista is compatible with Apollo any more. I know OS XP will work

My HP Color Laserjet 2600n Printer is giving me error as

" 50.2 Fuser error " . then every time i have to reatart my printer.
please give me suggestion.

thanks and regards.

ajinmumbai