At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I have probleam with my camera Supercam AG-Dp 800heg.
I describe you that when recording start on my camera there was a lining shown in my camera viewfinder and also in recording. But when camera has been started about 5 or 6 minutes lining which is shown on viewfinder has less but not remove completely and when we play the cassette after recording lining has also shown. When we setting pedistal setting in my camera menu setting up down line also shown up down but not completely remove lines. So please solve my probleam. I am very much glade if you help me to solve this probleam.
There are horizontal lines seen when I turn on my camera. Before recording I have turn the camera on for about 15 minutes for the lines to disappear. A technician told me that the power pulse board needs to be replaced. I have been trying to locate this board on line but I am unsuccessful. Is he correct or can the problem be other wise. Where can I get parts on line?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
On my Vista desktop it worked directly, but I had the same error message on my Vista laptop when the scanner was connected through an USB hub. Perhaps the power is not sufficient?
Then i plugged the connector directly into the laptop usb port 2.0, and the driver was automatically installed and works fine!
the sound you refer to during recording on the ag-456up is probably bad bearings on the video head. unfortunately, this part is no longer available. any good electronic repair shop should be able to clean the lens. a new battery should be available from wal-mart, circuit city, best buy, etc.
3 electro chemical capacity in the 3700 series on the camera head board.
change the chemical rear the DAC and above the ADC for process digital signal.
The name of the capacity: c3 c6 c9 in the 3700 section on process board.
The capacity is a part of filter the reference signal out of the DAC for ADC reference for ic1 ic2 ic3...
If the capacity is dead a sinusoidal signal appear for the red blue and green reference voltage and the result is a parasit signal into all camera.
You can measure a 50khz signal on the composite video signal.
Hello Situ,
If you must Change the erasing head's supply filter (capaciter) then change the audio erasing Bios OSC, transformer supply filter tantlem capaciter, the problem will be clear.
The noise is most likely bad bearings in the video head assembly. No longer available from Panasonic. The b/w recording problem is most likely caused by a bad video board inside the camera. Unfortunately, the video board is also no longer available.
×