Question about Konica Minolta bizhub C250 All-In-One Laser Printer
C0204 - Tray 2 Elevator failure - The Lift-Up Sensor is not blocked even after the lapse of a given period of time after the lifting motion has been started.
1. Turn OFF the Main Power Switch.
2. Turn Main Power Switch ON while pressing the Utility/Counter key.
3. Touch [Trouble Reset].
4. Check to make sure that [OK] is displayed and the it has been reset.
5. After turning off the Main Power Switch, turn it on again more than 10 seconds after and check if the machine starts correctly.
Reset your Toners and Imaging units for Minolta Bizhub and CF series.
Posted on Nov 27, 2009
This error code means that tray 2 lift has failed take all the paper out of the paper tray and check to see if some of it is folded under or up the side of the stack . the error code is reset by leaving the machine on and opening then closing the front door. if the paper is loaded correctly and the machine shows the error code again then probably the lift sensor will have to be replaced.
Posted on Nov 28, 2009
Thanks to Chip Reset - I had cleared all the paper trapped above Tray 2 (where the trouble was), but the printer still wouldn't recognize it, kept telling me it had to disable Tray 2 or it wouldn't work...until I found the solution, above. NOTE THAT THE "MAIN POWER SWITCH" must be turned off and - 10 seconds or more later - back on. In my case, I just unplugged the machine and plugged it back in (after following Chip's recommendation above). Tray 2 works fine again - GRACIAS! MERCI!
Posted on Sep 14, 2012
Tips for a great answer:
Jun 12, 2014 | Konica Minolta bizhub Office Equipment &...
Jun 07, 2014 | Mercedes-Benz Sprinter Cars & Trucks
May 28, 2014 | Konica Minolta bizhub C450P Laser Printer
Mar 19, 2012 | Philips Televison & Video
Apr 08, 2010 | Konica Minolta bizhub C351 All-In-One...
Jul 12, 2009 | GE RM24930 Remote Control
13,796 people viewed this question
Usually answered in minutes!
Level 3 Expert
Level 1 Expert
Level 2 Expert
Step 2: Please assign your manual to a product: