Wireless mobile mouse 4000, usb gets hot, and usb not recognized

I have seen power supplies going bad, killing many components, most especially anything connected via USB.

When you replace the Battery on a Wireless Mouse you have to link the Mouse again with your USB receiver. There should be a Button on the bottom of the Mouse that could be marked, Reset, or Link or something similar. Just turn on your Mouse and hold this Button for a few second until the USB receiver finds the signal.

the USB receiver for your mouse is defective, DO NOT USE IT it could damage the USB port of the notebook replace the wireless mouse

Good luck!

Go here:
http://www.microsoft.com/hardware/download/download.aspx?category=MK
And download and install the software for your mouse

please check the battery of you mouse if not have complete charged then replace the battery and then keep pressing the button for 2-3 minut which is located on wireless device and then mouse will work fine.

I have a similar problem with my A135-S2286. I noted that the mouse pad area got hot, but I found it was the Wifi card. After getting hot, the computer stops recognizing USB devices and finally the computer gets stuck.

Try turning off your Wifi and please let me know if it works.

Normal 0 Try disconnecting the camera from the USB port and reinstall the CD software program that came with the mouse. When the program asks you to connect the camera to the USB port, do so and it should work. Hope this helps. Bud

I have the same mouse and I had to install the intellipoint 6.1 software that came with it, and it worked flawlessly. Then I sold a few of them that I had and mixed up the dongles in the sales and now none of them work. Trying to figure out if I can force a recognition or are they proprietary to only one mouse. Go to microsoft and see if the intellipoint 6.1 is a download.

I called microsoft and they could not fix the problem, stated it was a faulty device and are sending me a new one.

have you checked the battries in the mouse as the battries that com with the mouse don't last long and have you pressed the connect buttons on receiver and mouse as somtimes usb power receivers loose connection on laptops try this one. hope this works