I just bought 2 ADEMCO 5804 Key Fobs for my ADEMCO LYNXR-EN Security System. Does anyone have an idiots guide to step-by-step procedure for programming the Fobs to my Alarm? I do not have the installation manual for my Security System.
Re: I just bought 2 ADEMCO 5804 Key Fobs for my ADEMCO...
Yes i can help you who monitors ur system because your gonna need the installer code to get into programming or power down the sytem then hold down the *and # to get into programmming
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
multiple low battery ones in sequence , mean a remote low battery. There is usually only one reporting zone on the remote (panic). That would be why only one zone shows alarm.
learn the two into the Code Encryptor receiver by pressing and releasing the black button on the receiver. The red light on the receiver should come on. press and release the closed padlock button 3 times, the red light on the receiver should go off
A common problem that I see with customers and these remotes is that they dont hold the buttons down long enough. It should not be like a tap, more like a press and hold for about 2sec. GL
The AC power wires for a Lynx (actually, almost any alarm panel) are from a transformer--there is no "hot and ground". It doesn't matter which wire you put to which terminal, as long as you connect them to the AC connections.
Turn the alarm off two times. If it still indicates A/C not ready, press the * key and it will tell you what zone is open or what zone has a low battery.
you have get into programming by disconnecting the power then reapplying it (battery first) within30 seconds press1and 3 ( same time ) until you see 20 flashing. press #20 and the installer code will be displayed one number at a time. If you want to change it press *20and whatever 4 digit code you want the installer code to be. Next Press *99 The system will reset and come out of programming
×