Hi sir/madam hi I would like to make a question about my Access Point because it have a problem it don't have any signal to be login i try to reset but still not working so could you please advice me about this problem?

Hi sir/ madam already deleted my qeep account and i regrate it . Please re open it sir/madam my id is .Nf

Configure your network with an administers pass word and other computers won't be able to access.

Don't worry i will help You can master reset the Phone using the master reset code,try master reset code at here
Unlocking4free

This might help:

In Device Manager, open your wifi and/or Network Adapters Properties, under Power Management tab, disable the "Let Windows turn off this device to save power".

The default settings are:
Username: admin
Password: admin

If that does not work then you may have to do a hard reset on your router. Note that this will wipe out any custom settings that may have been set on the router.

Hi,

Every wireless device have a reset button, you just find it and press it your router will be reset.

Regards

Ashly

Epson has not released a printer driver for Win 7 and this printer.

My best guess at this point is that Epson has chosen to stop any additional driver development for this model printer.

Don

dear sir/madam
please use the following site for bluetooth software.

http://www.newfreedownloads.com/find/bluetooth.html


please vote

regards
murali

dear sir/madam,

On back of the router there will be the RESET button. It a small hole there. Just press the hole with ball point pen it will be the reset.

thanks
good luck

Here is what you can do. You need to access the setup page of your Dlink Access Point.
1. connect a computer directly to the access point (via ethernet). Then assign an IP address on the computer (IP: 192.168.0.10 Subnet Mask 255.255.255.0 DG: 192.168.0.1 ). It is necessary for you to assign an IP address because your access point does not have the ability to assign an IP address to the a computer, its is not like a router.
2. After you assigned an IP address, you can now access the Dlink Access point's setup page. To do that open your browser in the address bar type http://192.168.0.50 (this is the address of your access piont) and it will ask you to put a username and password. Just type admin for both username and password field. And it will take you to the setup page of the access point.
3. To enable a wireless security, just click the tab on the left hand side that says Advanced, it will populate the options under Advanced and select security. On the main screen you will now have an option for security modem, you can select wpa-psk, then on the Key box you can type any password that you want (8-63 characters). Then click update there at the bottom of the page. If you also want to change the name that the Access point is broadcasting you can go to the on the left hand side that says Wireless and put any name that you want on the box that says SSID. After that click updat button again.
4. Now after updating the settings, You can reconnect to the network. And this time you will now be asked for the network key. Just type your network key. That's it.

Just reply to this post in case that you need more help.