I turn the tv. on , the green light comes on then it goes right back off. I unplugged the tv. to reset , but it made no difference.
When you turn it on and it shuts off---ON THE FRONT OF THE SET PRESS AND HOLD BOTH THE MENU AND INPUT(DEVICE) BUTTONS TOGETHER FOR AT LEAST 5 SECONDS AND RELEASE BOTH BUTTONS.
Power light should blink a two digit error code---for example: 2 blinks, a pause and 2 blinks--This is the most common error code.
Let me know what error code you get and I will tell you what it means and if 2-2 what the problem is.
If this information helped you, rate this solution as I do this here for FREE.
SD TECH
I have a mitsubishi rear projection tv (medallion).. The power will not turn on... blinking green light. I have tried reset button. Unhooking wires to tv front panel for remote use only... I am out of ideas. help
I have the same problem also,My tv is blinking one-two, can you pls tell me what that is? Thank you
1,2 is no error detected, try unplug the set for a few minutes and then when ready turn it on again and if green light goes out do self check again, if you unplugged set it will revert to no error found.
SD TECH.
A good idea is post a free question here attention SD TECH and if I see it I will assist you.
Attn sd tec, I did what you said and now I'm getting code 2-2. Also on another of your treads I attempted to unhook the front keyboard by unplugging the two wires and turning it on with the remote, that did not work either. Thank you for your time and help, what's the next step? Can you tell me what 2-2 is?
×
1,013 views
Usually answered in minutes!
ok when i hold down the two buttons it has 2 blinks 3 times what does this mean
×