I have had this phone for just under 3 months. When opening the phone and looking at the screen, the colors on the pics came up with a rainbow tint to them and now it just opens up to a blue screen. I have taken out the battery numerous times, which did help for a short period of time, but now all I get is the blue screen. I can't see who is calling or read any text messages. Is there something I can do to fix this? Thanks!

Hey!
If your screen is wrecked you might have to put your phone into your local phone repairer if you are still under warranty. But if you aren't covered you might have to buy a replacement screen and a how to install video should be on YouTube.
Hope this helps!

The cause of rainbow colored tint is the over charging. Mostly of the phone which is over charge can cause rainbow colored tint.

There is a problem with the connectors desoldering in the tv. My mother in laws tv did this after 2 months. Should be warranty issue if less than year old

ur tv needs to be degaused using a degausing wand or ring. mos def needs to be taken to a professional to be done.

Fuzzy,blury picture in CRT tv tube.Tv in long use not repairable.Tv tube is dying,it junk.

take the front panel off the tv, the bottom, you will see 6 little nobbs :::, use them to adjust your picture, the left 2 should be for red, the middle 2 dlue, and right green, top 3 are for focas, those are probabily the ones you want to adjust, bottom 3 are for turning the colors up and down, mess with those untill pic looks good

Colorimetre HCFR software
AVC HD 709 calibration disk
Spyder2 colorimeter (I know most prefer the Eye-One meters, but the Spyder2 was available from my job at no cost)

Here are the settings:

PS3 Blu-Ray player

Output Format (HDMI): Y Pb/Cb Pr/Cr (important!!! NOT RGB output)
BD 1080p 24hz Output (HDMI): On (this TV can reproduce video at 48hz for accurate 2:2 pulldown)
Y Pb/Cb Pr/Cr Super White (HDMI): On (not sure if this matters)

42LG50 Settings

Aspect Ratio: Set By Program (Personal Preference)
Picture Mode: Expert 1
Backlight: 50 (Personal Preference)
Contrast: 54
Brightness: 54
Sharpness: 40 (Personal Preference)
Color: 50
Tint: 0

Fresh Contrast: Off
Noise Reduction: Off
Gamma: Medium
Black Level: Low
Real Cinema: On

White Balance: Warm
Method: 10 Point IRE

10 (-3,8,-16)
20 (15,24,-21)
30 (20,36,-22)
40 (3,19,-40)
50 (8,34,-41)
60 (10,50,-20)
70 (-5,50,-8)
80 (-16,50,18
90 (-14,50,30)
100 (-22,38,21)

Red Color: -3
Red Tint: 0
Green Color: 10
Green Tint: 0
Blue Color: 14
Blue Tint: 0
Yellow Color: 0
Yellow Tint: 1
Cyan Color: -11
Cyan Tint: 0
Magenta Color: 0
Magenta Tint: -2

Take time to get used to the settings, you may think the screen looks dull at first. The truth is most people have way too much contrast on their TVs.
These settings will also work for Cable or Dish hookups, in which case you may change the Noise Reduction option to Medium to reduce signal noise.

OR....

2POINT IRE

Backlight: 65
Contrast: 55
Brightness: 45
Sharpness: 50
Color: 45
Tint: 0

Fresh Contrast: Off
Noise Reduction: Off
Gamma: Medium
Black Level: Low
Real Cinema: On

White Balance: Warm
Method: 2 Point

Red Color: 3
Red Tint: 0
Green Color: 9
Green Tint: 2
Blue Color: -1
Blue Tint: 0
Yellow Color: 6
Yellow Tint: 5
Cyan Color: -1
Cyan Tint: 1
Magenta Color: 2
Magenta Tint: -1

Sounds like both the convergence ICs need to be replaced. they are STK392-110 you can get replacements with free instalation instructions with pics at the following link.
http://servicemanuals.vstore.ca/

Turn down your color and see if the screen has a normal black & white screen. If it doesn't then the CRT is bad (picture tube). If it is black & White then you have a either lost your red or blue.That problem will be in your video driver circuit of which a service center can handle.

i problem with tv by that icant get pic from tv