Apex dvd player door will not open - Apex Digital AD 1115

The programming codes for an Apex DVD player will vary depending on the specific model of the player and the type of remote you are using. Some codes that are commonly used for Apex DVD players are:

1. 599
2. 661
3. 677
4. 678
5. 679

You will need to check your remote control's instruction manual for the specific codes that work for your remote and the Apex DVD player you have.
To program your remote control to work with your Apex DVD player, you will need to follow these steps:

1. Turn on the Apex DVD player
2. Press and hold the "Code Search" button on your remote control until the indicator light stays on.
3. Press the "DVD" button on the remote control.
4. Enter the code from the list above that corresponds to your Apex DVD player. The indicator light will blink if the code is accepted.
5. Test the remote control by pressing the "Power" button. If the player turns off, the programming is complete.

Try to reset the DVD. Unplugged it for 24 hours... If it doesn't work it need service because the internal rotating part need replace.

unplug and open in up and retrieve the disk. should work again.
Apex is a crappy brand and is thought of as the one year throw away special.

I don't have the original control remote for Apex Ad-1201 DVD player. I would like to use my Universal Remotes: Radio-shack USA "flag" 4-IN-ONE Remote and / or RCA 312W three component remote. I got the codes from the manuals but my DVD player doesn't work or turn off (only ejecting; open and close) with pause button. Could I get a possible code (s) for these Universal Remotes?

change the motor belt charge it´s located downside the disc tray

READ THE MANNUALS, OR IF THERES ANY RESET BUTTON, THEN PRESS IT, OR BY OPENING THE SYSTEM AND IF THERES ANY CMOS BATTERY REMOVE IT, THEN REPLACE IT AFTER MINUTE..HOPE IT WORKS

Probablemente la banda del motor de carga esta en malas condiciones,esta se encuentra en un lado debajo de la charola del disco hay que cambiarsela.

leaf switch is defect. It tells if the door is closed or open. not very expensive, thing is to try to find it. usually two wires. good luck
etienne

Bad load belt,,,,load motor just spinning,have belt replaced

Sounds like a mechanical problem of sorts . Hard one to call without opening and looking. Before you tear it apart I would try calling Apex Digital At 866-427-3946, as they are very good with there customers. Good luck