I HAVE A TOYOTA RAV4 WITH RADIO CONTROL ON STEERING BUT CHANGE HEAD UNIT TO PIONEER AVICD3 AND WANT TO CONNECT CONTROL TO STEERING

is there any check engine light on
are all drive belts on
vvt has nothing to do with the steering
is power steering oil is full in the reservoir
Hi thank you for update
you can start the car and even while it is running the steering is the same, any chance the hose are not install the wrong way if you had removed, if you jack the front wheels and turn ignition on car not running can you turn the steering left and right or end to end see if this work? did you check the compression on the cylinder which is misfiring
Can you start your car and were are you based

Sorry we don't have that, you could try a company called Crutchfield

you must replace head unit, as an assembly no way arround that I know.

Check under the passenger seat or in the glove compartiment!Good luck!

the computer has an auto reset mode that if a component is faulty but not serious it will reset itself until workshop computer is connected,then if fault still exists it will show up on the fault memory.If the light comes on and stays on then worry......

is it in the unit itself have a look carefully if theres a load button on the unit they go into the unit if theres no button indicating this look hard for the changer should be in dash in the unit itself

that plug at the back is not for sat radio. It is for use with steering wheel controls. You have the blue plug at rear of stereo and that is the plug for sat radio. Ericson electronics is contracted to build the sat compatible units that wire into this radio through the blue. plug. if you are using 3.5 plug audio control from a portable sat receiver, the you will need to buy an aux input cable for your stereo..