Fax centre F110

Guarantee ? But first ask what can happen with the machine, like undervoltage on the selected mains voltagegroup at home, or just technically bad luck with the product.

Sunbeam Corporation Head Office
U5-6/13 Lord St Botany, NSW
(02) 9695 9999

Customer Contact Centre 1300 881 861
National Sales Fax 1800 681 826
Sunbeam Factory Outlet 288 Whitehorse Rd, Nunawading, VIC
(03) 9894 3919

Click this help link below to go through troubleshooting the problem:----Check Powertrain message and Safety Mode Reduced Performance on Holden VZ Commodore?http://howtobyme.blogspot.in/2012/02/check-powertrain-message-and-safety.html
-----------Power train drive train message on dash?
http://howtobyme.blogspot.in/2012/02/check-powertrain-warning-light-on.html
-----------check power-train message with orange engine light came on?http://howtobyme.blogspot.in/2012/02/check-power-train-message-with-orange.html
----------This will help.Thanks.

You don't really need to block incoming faxes, but just set the machine not to automatically answer them. This figure is from the manual:



Press the MODE button until you see MANUAL displayed. In manual mode you need to answer and start receiving a fax yourself from the machine.

You can download a copy of the user manual from Xerox if you need it.

The lines may come from the toner/ drum cartridge. Try stopping the job by opening a cover, and see if the defect exists before it reaches the fuser.
The fuser for the F110 is PN 126N00235
The toner/ drum unit is 013R00605 (several alternate numbers exist)
And it could also be the transfer roller 022N02107

Hope that helps

Whit
Item, Inc.

you could perform a soft reset. the memory should be cleared and new prints recognized. unplug the printer from ac power for about 10minutes the plug it again and start printer.

Unplug your fax machine. It's conflicting with your fax modem. If you have an All-In-One Fax , disconnect it from the telephone line.

Google a business called " the parts drop" give them a call and ask for Britt. I dont work there, but have done business with them for a long time. Honest and professional, and fair. Give them a call, they will help you out.

Unplug the power cord for 10 seconds

You must contact the sending party and tell them to STOP if the above does not fix the problem.

That is due either to memory corruption of a bad main board.
the memory reset is really complicated. If you want to provide me your E-maill address it would ne easier to explane.

We had the same memory full problem. Just unplug the main switch and it will automatically reset the printer and you will be able to send and receive faxes after.