The WII Fit board will only stay on, if there is a game loaded and waiting to access the board. For instance, the WII Fit game will prompt you to turn on the the WII Fit board. If you turn it on before prompted, the WII Fit board will turn itself off.
However, assuming you do not have a hard ware problem and you have already put in fresh batteries. you may have to resync the WII Fit board and the WII. Try pressing the red button on the WII Fit Board (near batteries) and the WII itself (near the SD card slot).
This is a problem occurring in all the wii consoles....... this is
mainly because of some error in board .....as a result it leads to the damage of ur wii
....................try to update your
system .......... if its working good then better download this Repair Guide for
further information .........
CLICK HERE to download
SOURCE: my wii fit board will not turn on. when button is
Re sinc it.Open the front cover on your Wii and push the red button there, then open the batteries cover on your Wii fit and push the red button there.If this not help Open thre front cover on your Wii and push and hold the red button for 20 seconds.This will clear all sync devices.Now try again to sinc Wii fit.In this case you need to sinc your WII Remote/s again too.If and this not help may your Wii fit need service.
SOURCE: Wii fit board won't work
Hello,
Here you have different procedures on what to do if you get that error message. Please get back to me if nothing works.
The exact procedure is:
• Even if the battery level is strong, try the following:
Remove the batteries in the Wii Fit Board for at least 1 minute…… better 15
Try these steps!
1
Turn the Wii console power OFF by pressing the POWER Button on the
front of the console. Unplug the power cord from the wall outlet for a
few seconds. After a few seconds have elapsed, plug the cord back into
the wall outlet.
2 Turn the power of the Wii console ON. When
you see the Health and Safety screen, open the small flap on the front
of the Wii console to find a red button labeled "SYNC." Press and hold
the SYNC Button down for 15 seconds. This will clear all the syncs on
the Wii, allowing you to get a clean start to begin the process
described below.
3 After holding the SYNC Button on the Wii console down for at least 15 seconds, you can now "re-sync" your Wii Remotes:
a
With the first Wii Remote you wish to sync, remove the battery cover on
the back of the Wii Remote to find a small red button just below the
batteries.
b Press and release the small red button just below
the batteries on the Wii Remote; the blue lights on the front of the
Wii Remote will blink.
c Quickly press and release the red SYNC button on the inside of the white flap on the front of the Wii console (picture).
d
When the Player LED blinking stops and stays lit, the syncing is
complete. The LED that is illuminated indicates the player number (1
through 4).
4 Start the game from the Wii Menu, then sync the Wii Balance Board from the opening screen of the game.
Hope it helped.
SOURCE: wii fit board wont sync
I have a wii fit board that the power button won't stop flashing I have tried to reset the sync button changed batteries twice still not working.
1,418 views
Usually answered in minutes!
×