Mother want power up, no led or nothing. the power supply is good. any thing to try or check

Power Supply is bad. Plain and Simple. Replace it. Regards, joecoolvette

Not trying to be condesending but start simple and work your way up.
1. strip dow board to;
a. known good older processor
b. known good single memory stick
c. known good power supply
Test
move memory one slot over
Test
Move memory over one slot
test
move memory to last slot
test
You have tested the variables if still not working you have a bad mother board.
contact foxconn for replacement.

Just change the SMPS (Power supply)and try again... if it is not solves u r problem

Mother Board is faulty..Visit Service Location

Sounds like the Power Supply is bad likes its not able to power on itself. Best thing to do, try a different known good power supply and attach it to the motherboard, if you get the same symptom with the machine not powering on then its a bad motherboard. If the machine does power on then you know your original power supply is bad.

hi..the mother is need a complete the supply on board pin..then double cheek the memory..thanks..Good Luck...^_^

Try removing the power cable from the power supply. Wait 10 seconds, and replace it again. Try powering up the computer. If it doesn't power up, check that the motherboard has power (there should be a LED on the board which is lit up. Of course, check the fuse also in the plug.

If the LED is on, you have a failed motherboard / Switch. If the LED is off, then you have a failed power supply. Beware though, if the PSU has blown, it could easily have taken the motherboard with it.

hi im josh in cebu phils. may i help you? not open or no boot. If it doesn't boot or power on and no prsence of current on your pc. The main problem is motherboard. it may be no current is running on the board.because the supply chord was lost or not enough supply to make the motherboard execute.check if your power cable 16 pins is connected and the 4 pins 12 volts power support.if it loosen thats the problem. Sometimes the compatibility of your processor and the mainboard is needed.if both of these is for the first time check the compatibility of the mainboard and the processor in your support manual. good luck!

no beeps.
I tried 3 different power supplies.
I stripped out the memory and hard drive and put it in the dumpster where it belonged.
Steve

Hi,

Try doing flea power & the power cycle.

1. Disconnect all the peripherals like keyboard,mouse,printer, scanner & monitor and power supply from the CPU.

And press & hold the power button for 1 min, it will release the flea power from the mother board.

Restart the system & check.

2. Disconnect everything.wait for 5-10 minutes and then connect every thing & start the system.

Restart the system.

Hope this helps.

Good Luck.

Live, Love, Laugh.

if this is a built sustem out of the box with old monitor try another monitor oddly enough some arent compatible, you can check by looking at the prong patern.