How do you program a D770 remote? - RCA D770 Remote Control

hold down code until it stays lit, then press tv then keep hitting channel up or channel down (either one can be used, keep pressing channel button til tv changes channels when it does press enter, or ok if enter is not there, it may take awhile maybe a few channel pushes up to 200 and up times, you use this method when you don't know the code for your tv. Hope this helps.

The DRD486RH is both IR and RF capable but the remote that you have is obsolete.

trying to program universal remote contol VET 606 LP 12 for TV FUNAI.I need manual for programing.

Dragan Stefanović
Novi Sad
Serbia
e-mail: [email protected]

i lost code of book

Here you find RCA D770 codes :
How do you program an RCA d770 universal remote

Panasonic are : 1003, 1054, 1062, 1170

Check this link to Wiki,

http://wiki.answers.com/Q/How_do_you_program_an_RCA_d770_universal_remote_if_you_don't_have_a_code_search_button

http://download.ethomson.com/english/RCA/ACCESSORIES/IB/D770.pdf
I had trouble with the ethompson link

Turn on device.
Press and hold the button for device you want to program ( TV etc),
press the on/off button and hold until the LED turns on, and then release both buttons.
Then, point the remote at the device, press and release PLAY and wait 5 seconds or until the LED stops flashing. If the device does not turn off, then continue to press play and wait the required interval (for a maximum of 20 times) until the device turns off.
When the device turns off, stop pressing play.
Press REVERSE, wait two seconds and continue doing this until the device turns back on.
To finish programming, press and hold STOP until the LED turns off.


I had trouble with the ethompson link

same thing

Programming For TV
1. Turn on the device to be programmed.
2. Look up the brand and code number(s) for the device on
the code list at the end of this section.
3. On your remote control, press and hold the device button
you want to program.
4. Enter a code from the code list.
5. Release the device button, and then press ON•OFF to
see if the device responds to the remote control
commands. If it doesn’t, try pressing the device button
and then ON•OFF again.
6. If you get no response, repeat these steps using the next
code listed for your brand, until the device responds to
the remote control commands.

Emerson ..................1004, 1006, 1012, 1014, 1023
..................................1024, 1025, 1026, 1027, 1028
..................................1029, 1030, 1031, 1033, 1034
..................................1035, 1036, 1038, 1039, 1041
..................................1042, 1043, 1044, 1046, 1047
..................................1123, 1124, 1162, 1171, 1176
......................................................1177, 1179, 1191

Your user manual is available for download and option printing at the following link :
http://www.retrevo.com/s/RCA-D770-Universal-Remotes-review-manual/id/402ci568/t/1-2/

try this...

http://wiki.answers.com/Q/How_do_you_use_an_RCA_d770_to_program_your_DVD_player

hope that helps.

Go to this link. Copy and paste the whole link this will get you going. 

 

                        JR57Gard

http://support.rcaaccessories.com/doc/Device_Documents/manuals/D770_manual.pdf?deviceDocId=73&docid=540&docid=983&navtypeid=6&pagetypeid=7&prevPageIndex=2&selectedmodel=D770&selectedFamily=television&nvty=m