My Toshiba 62 mx 195 Projection tv has an overlap of the bottom half of the picture on the top half of the screen !!!!Any suggestions!
SOURCE: Problem With Colors
You need to re-solder the circuit board that contains the STK
convergence modules. They're on the center circuit board attached to an
aluminum heat sink that's about 8" long and 6" tall, about dead center
in the circuit board. You may be able to recreate the problem (hour
glass effect) by gently moving the heat sink (which the modules are
connected to). This gives the hour glass effect on the picture and the
advanced convergence screen. This is an indication that the modules
pins aren't solidly connected (meaning soldered) properly. Remove the
circuit board and clean the old solder off & resolder the modules
pins to the circuit board reconnected the board and then retest by
again pushing on the heat sink. This is a caused by a minimum
effort (a.k.a. minimum cost) solder job, probably done in some 3rd
world sweat shop. The "factory" job was good enough for 3-4 years but
the heat (and these modules do create a lot of heat) and stress created
from repeated use eventually takes it's toll, weakens the pin
connections and our problem occurs. take the appropriate cautions
working around the high voltage of the set & use a non-conduting
piece of wood to push the heat sink when we doing tests.
If this doesn't work, the modules need replacing.
Best of luck, hope ya fix it.
SOURCE: 50hx70 blue projection light is concaced at top and bottom of tv
When the convergence amplifier ICs go bad (STK392-xxx), they RARELY cause more than one color to go out. The fact that the top and bottom of the picture are effected indicates the vertical convergence IC. Replace both, and while you're in there check the bias resistors... it is likely one of these is open. Once the ICs have been replaced (as well as any open resistors), customer convergence followed up with the auto convergence should do the trick.
SOURCE: i have a tz61v61 toshiba
If your TV looks 3D, warped, or distorted it likely has a convergenge problem.
If however it just looks dull, washed out, redish, or if it looks like objects on the screen have halos the fluid in the lens has soured.
You can search google for parts or you can get the parts with repair instructions from sites such as www.TvRepairKits.com
SOURCE: its a toshiba 62 inch
Visit this website for List of Parts/Part#
Encompass Parts Distribution 1-800-638-3328
They offer free Service Manuals to some Models.You can Print them out online.
131 views
Usually answered in minutes!
×