My (new to me) apt has an electric jennair stove top -no instruct

Put the oven on for an hour at 350'F. It should dry everything out.

You have probably accidentally disconnected some wiring whilst moving it need to re explore

30amps at 220vac will run about 6 to 7 kilowatts, your oven is probable about 3 kilowatts.

Hello. the installation of wall mounting bracket is not too difficult. you will need a drill, some bits, and a scrrewdriver. you will also need an electrical outlet at that spot to plug in the microwave.

Jennair makes a bracket kit for each microwave. Call any jennair dealer, have your model # handy and they will get you the bracket you need, also ask specifically for the instructions.

Either works. Do what is easier. If you g with the 3 wire the white on the range has to be connected to the chassis as well as the terminal connector. Eric

You need to remove the cartridge then all of the screws that are around the inside perimiter of the well. You may also need to remove the control panel via the screws securing the top trim and the bottom flange. The part numbers for the wires with contacts are as foloow: 71002326 blue wire, 71002604 brown wire, 74005845 violet wire and w10116778 yellow wire. They should retail at @ 7.-8$ each.

http://www.jennair.com/catalog/product.jsp?parentCat=2&cat=69&prod=1462&tabOption=specs#info

Good Luck and Please Rat FixYa!

The filter in the jenn air can be run through the dishwasher. clean the outside of the oven as best as you can before you start the self clean cycle. NEVER!!! use oven cleaner inside a self cleaning oven. or on the gasket. . You can use a degreaser or oven cleaner on the cooktop on any stainless steel, procelain or chrome surface. Don't get oven cleaner on painted or aluminum surfaces. Rinse off very well.

there is a thermostat on rear of oven that has gone bad.Unplug unit remove back panel and you will find it there.You can also undo your locking mech. and put back togather to get door open.

Try carefully cleaning around the ignitors. Also clean hole in burners. Clean the holes closest to ignitors. This can be caused by a crack in ignitor, this requires replacement.