Automatic Antenna I recently bought a nissan altima with a DRB2475 clarion installed, the system works correctly with the exception of the Radio, the problem i believe resides in the antenna which apparently at one time was controlled but now it just stays down, so are there any solutions...

It appears this model may only be for the Japanese Market. Clarion.com don't have a manual for it. Crooooober says is comes direct from Japan.

Owners Manuals Download Service - Clarion

https://www.clarion.com > support > owners_manuals

Clarion is a leading manufacturer of high-performance in-car entertainment systems - from acoustically advanced amplifiers, speakers and subwoofers to ...

HC307-A Clarion B8260-7997G ' HDD Navigation(digital)

https://www.croooober.com > item > cparts > HC307-A...

Get your next HC307-A Clarion B8260-7997G directly via Croooober Japan, ... 20P) / radio antenna conversion code / iPod connection cable / manual only ...

NISSAN Genuine HC307-A Clarion MAX670 Equivalent

https://www.croooober.com > HDD-Navigation-digital

Serial No: 0019379 Clarion made (part number: B8260-7997G) Body Instruction manual GPS Power wire iPod cable Sensor coupler A set of radio antenna Behavior ...

Pull the radio and check the antenna jack. It may be unplugged.

yellow battery
red accessory
black ground
purple right rear + speaker
purple/black right rear -
green left rear +
green/black left rear -
white fr left +
white/black fr left -
grey fr right +
grey/black fr right -
blue auto antenna
blue/white rem amp
brown phone mute
orange/white illumination

pls rate people arnt rating hope this helps

the brown is a mute wire. i dont recomend hooking this wire up

i would check the antenna connections

If you used the 2 plug nissan radio harness, there should be a blue wire on there which is the (power antenna) even if your car doesn't have a power antenna, this wire needs to be connect to power on the am/fm amplified ant which is used in many nissan cars.

if the jensen has a blue or a blue/white wire, connect it to one of those. if not, you can always connect it to the red ACC wire. that should solve your reception problem..

hope this helps

im pretty sure the serrated edges face to the rear of the car that is what grabs to hold it in place good luck

The RED from the clarion wire must be hooked up to a switched power source ... that was wired to your old radio, then press the reset switch, and it should then turn on.

Found it on the Clarion Support Page;

http://clarion.com/us/en/MungoBlobs/82/1021/DRB3475(Manual).pdf





Best of Luck.

Yellow - +12V Constant Power Red - +12V Switched (accessory) Power Blue - Power Antenna Blue/White - Amp Turn-on White - Left Front Positive Speaker Wire (LF+) White/Black - (LF-) Gray - Right Front Positive Speaker Wire (RF+) Gray/Black - (RF-) Green - Right Rear Positive Speaker Wire (RR+) Green/Black - (RR-) Purple - Left Rear Positive Speaker Wire (LR+) Purple/Black - (LR-)