Our Maytag Jetclean Dishwasher EQ Plus will not turn on (MDB9150AWS) and we cannot find a repair manual to troubleshoot through the problem. Maytag does not offer repair manuals on this model. Any suggestions?

Most likely the control panel is defective.

The best dishwasher soap we have found is Finish Quantum and they have good rinse aid too

Jiggle the water level float sensor .It is stuck .

either the control board or the control panel needs replacement. Most likely the latter. There is a possibility that both parts failed also. Usually water gets inside the touchpad, corroding and shorting the touchpad. Good luck

screens , chopper ,and spinner arm stopped up take apart and clean

I have the same dishwasher with the same problem, try pushing the delay/resume button, then the drain/off button. When the lights go off start your wash cycle.

Hi, The mesh does not open. You will need to GENTLY clean each section with running water. Are you using powder or liquid soap?
The most common thing that plugs them is food particles. This unit is best served by pre-rinsing the dishes. The mess gets plugged to easily.
I hope this helps.

Vic

the door seal has gone better change the door surround seal also. check for case damage and obstructions aswell.

Try pressing delay/resume then drain/off. In some cases you might need to do delay/resume then drain/off twice.

My Maytag Jetclean Flexiload is 4 years old. Upon choosing a program the timer counts down but little action is heard. Near the end of the cycle an Error message comes up. The dishes are stiil uncleaned.