RCA L46WD22 firmware

hi try to make to do again firmware update, something went wrong on the previous update. the orange light is on becaouse the printer firmware is wrong, is in the upgrade mode.

Why the need for firmware upgrade?

The power light is green, it is working, the problem lies with your internet connection.
1. Check the cabling.

3. Check with your ISP as to what the problem is.
2

These blinks (Flashes) are fault indication, and known as blinking codes. From the number of blinks occur at one time switch ON; you can get an idea about the faulty circuit stage inside the TV. This will make repair easy. For more information, check these link s
http://electronicshelponline.blogspot.com/
http://electro-medical.blogspot.com/

It is not predictable about the faults that can be occured due to a lightning stroke. Contact any service technician to set it repaired.

Click the link below :----http://wikisolutions.blogspot.in/2012/02/get-free-answers.html

http://support.ttetech.com/en-us/softwareupgrade.html

On this website if you look halfway down you should see L46WD22 firmware instructions and download. Read and follow the instructions to the letter as this has the potential to further damage your unit.

Hope that helps!

You probably want to contact RCA technical support. As far as I know though there is no force that you can do and most likely you will have to replace the main board. Anyway contact RCA technical support. Was there a particular reason you were updating the software?

Found a FIX.... Bought a new Sony ... I will never buy another Thompson product G.E., RCA TTE...None of them. The support is a joke. The "warranty" is as dependable as the product. COMPLETELY WORTHLESS

had the same prob with th1100 (512 mb ver) went to rca site, downloaded firmware upgrade. ran it 3 times with no result. finally checked the box "format data area" worked like a charm. hope this helps.

Are you sure you finalized the firmware upgrade procedure according to the instructions? This sounds a little like you pulled the plug a little too soon... Have you done it according to these instructions: http://www.olympusamerica.com/cpg_section/OMfirm.asp And kept the camera connected until the update was 100 % complete? If you did everything right, try reseting the camera - take the batteries out for the day, and see if it helps. if you're back to step one(the reason you did the upgrade), try the firmware upgrade again. If still it doesn't work contact olympus, and I hope you have a valid warranty. Good luck