When I inserts the Transcend JetFlash V60 16 GB Pen Drive in to system it shows the message like '' USB Device not recognized'' What the solution that I can get started with the Device.
Sachin Nalawade,
D.C.Office, Belgaum (Karnataka)
9880880540
Sometimes when a flash memory stick fails because it was not removed from the USB port properly. If the device is removed by just pulling it out of the USB port, it can cause the flash device to fail, you must click on the Safely Remove Hardware icon on the Task Bar and select the device you wish to remove and only do so when instructed to do so.
When the flash memory device appears to malfunction it maybe possible to restore it by reformatting it. Insert the flash drive into the USB port then Click on Control Panel - Administrative Tools - Computer Management - Disk Management.
Then right click on Disk 1 removable drive and click Format. After the flash drive has been formatted it will indicate that its Healthy.
You need to format the external drive. Format the drive as primary drive and in FAT32.
Insert the external hard drive into the USB port then Click on Control Panel - Administrative Tools - Computer Management - Disk Management.
Then right click on Disk 1 removable drive and click Format. After the flash drive has been formatted it will indicate that its Health
Check the Version of your USB via device manager see if it's version 2(USB 2.0 Root Hub), if so the problem might be the JetFlash it self, if not, you can down load a version 2 USB thru Microsoft.com :) hope this help
560 views
Usually answered in minutes!
×